Stimmen - 4, Durchschnittliche Bewertung: 4.5
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
2 Find your problem in the troubleshooting checklist below and take the indicated corrective action. If the problem persists after doing all of the above, consult your nearest Sony dealer. When the ?/1 indicator flashes Immediately unplug the power cord and check the following items. • Is the voltage selector set to the correct voltage? Check the voltage for your region, then make sure the voltage selector is set correctly. • Are the + and – speaker cords short-circuited? • Are you using only the prescribed speakers? • Is anything blocking the ventilation holes on the rear of the system? After checking the above items and fixing any problems, connect the power cord again and turn on the system. If the indicator still flashes, or if the cause of the problem cannot be found even after checking all the above items, consult your nearest Sony dealer. General The display starts flashing as soon as you plug in the power cord even though you have not turned on the system (see step 5 of “Hooking up the system” (page 6)). • Press DISPLAY twice while the system is off. The demonstration disappears. “– –:– –” appears in the display. • A power interruption has occurred. Set the clock (page 8) and timer settings (pages 21 and 22) again. –“Check the setting” (page 21) –“Timer recording radio programs” (page 21) There is no sound. • Press VOL +/– or turn VOLUME control on the unit clockwise. • Make sure the headphones are not connected. • Check the speaker connections (page 6). • There is no audio output during timer-recording. Sound comes from one channel, or unbalanced left and right volume. • Place the speakers as symmetrically as possible. • Connect the supplied speakers. Sound lacks bass. • Check that the speaker’s + and – jacks are connected correctly. There is severe hum or noise. • Move the system away from the source of noise. • Connect the system to a different wall outlet. • Install a noise filter (commercially available) to the mains line. The timer cannot be set. • Set the clock again (page 8). The timer does not function. • Check the timer setting and set the correct time (pages 21 and 22). • Cancel the Sleep Timer Function (page 20). The remote does not function. • Remove the obstacle. • Move the remote closer to the system. • Point the remote at the system’s sensor. • Replace the batteries (R6/size AA). • Locate the system away from the fluorescent light. There is acoustic feedback. • Reduce the volume. The color irregularity on a TV screen persists. • Turn off the TV set once, then turn it on after 15 to 30 minutes. If the color irregularity still persists, place the speakers farther away from the TV set. 26GB CD/MP3 player The disc tray does not open and “LOCKED” appears. • Contact your Sony dealer or local authorized Sony service facility. The disc tray does not close. • Place the disc correctly. • Always close the tray by pressing Z on the unit. Trying to press the tray closed with your fingers may cause problems with the player. The disc does not eject. • You cannot eject the disc during CD Synchro Recording. Press x to cancel the CD Synchro Recording, then press Z on the unit to eject the disc. • Consult your nearest Sony dealer. Play does not start. • Open the disc tray and check whether a disc is loaded. • Wipe the disc clean (page 29). • Replace the disc. • Place the disc that this system can play (page 4). • Place the disc correctly. • Place the disc in the tray with the label side up. • Remove the disc and wipe away the moisture on the disc, then leave the system turned on for a few hours until the moisture evaporates. •Press N to start play. The sound skips. • Wipe the disc clean (page 29). • Replace the disc. • Try moving the system to a place without vibration (e.g., on top of a stable stand). • Try moving the speakers away from the system, or placing them on separate stands. When you listen to a track with bass sounds at high volume, the speaker vibration may cause the sound to skip. Play does not start from the first track. • Press PLAY MODE repeatedly until both “PGM” and “SHUF” disappear to return to Normal Play. MP3 audio track cannot be played back.* • Recording was not performed according to the ISO 9660 level 1 or level 2 format, Joliet or Romeo in the expansion format. • The MP3 audio track does not have the extension “.MP3”. • The data is not stored in MP3 format. • Discs containing files other than MPEG 1 Audio Layer-3 files cannot be played. MP3 audio tracks take longer to play back than others.* • After the system reads all tracks on the discs, playback may take more time than usual if: – the number of albums or tracks on the disc is very large. – the album and track organization structure is very complex. The album title, track title and ID3 tag do not appear correctly.* • Use a disc that conforms with ISO 9660 level 1, level 2, Joliet or Romeo in the expansion format. • The disc ID3 tag is not ver. 1 (ver. 1.0 or 1.1). * MHC-GX45/GX35/RG440S/RG330/RG310 and MHC-RG220 (European a...
Dieses Handbuch ist für folgende Modelle:Stereoanlage - MHC-GX25 (413.23 kb)
Stereoanlage - MHC-GX35 (413.23 kb)
Stereoanlage - MHC-GX45 (413.23 kb)
Stereoanlage - MHC-RG220 (413.23 kb)