Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
“SET (DAILY 1)” appears. 4 Turn jog dial to select DAILY 1 or 2, then press ENTER/NEXT. “ON” appears and the hour digits flash in the display. 1 2 REC SLEEP VOLUME ALL DISCS § 5 Set the time to start playback. Turn jog dial to set the hour, then press ENTER/NEXT. The minute indication starts flashing. 1 2 REC SLEEP VOLUME ALL DISCS § Turn jog dial to set the minute, then press ENTER/NEXT. The hour indication flashes again. 6 Set the time to stop playback following the above procedure. To check the setting Press TIMER SELECT and turn the jog dial to select the respective mode (DAILY 1 or DAILY 2), then press ENTER/NEXT. To change the setting, start over from step 1. To cancel the timer operation Press TIMER SELECT and turn the jog dial to select “TIMER OFF”, then press ENTER/ NEXT. Tip The power turns on 15 seconds before the preset time. 7 Turn jog dial until the music source you want appears. The indications change as follows: nTUNER .CD PLAY N nTAPE PLAY N 8 Press ENTER/NEXT. The type of timer (DAILY 1 or DAILY 2), followed by the start time, stop time and the music source, appears, then the original display appears. 9 Turn off the power. Timer-recording radio programs To timer-record, you must preset the radio station (see “Step 3: Presetting radio stations”) and set the clock (see “Step 2: Setting the time”) beforehand. TIMER 7 6 SELECT 2 3,4,5 1 Tune in the preset radio station (see “Listening to the radio”). 2 Press CLOCK/TIMER SET. “SET (DAILY 1)” appears. 3 Turn jog dial to select REC, then press ENTER/NEXT. “ON” appears and the hour digits flash in the display. 4 Set the time to start recording. Turn the jog dial to set the hour, then press ENTER/NEXT. The minute indication starts flashing. 12 REC SLEEP ALL DISCS § VOLUME Turn the jog dial to set the minute, then press ENTER/NEXT. The hour indication flashes again. 5 Set the time to stop recording following the above procedure. The start time appears, followed by the stop time, the preset radio station to be recorded (e.g., “TUNER FM 5”), then the original display appears. 6 Insert a recordable tape. 7 Turn off the power. When the recording starts, the volume level is set to the minimum. To check the setting Press TIMER SELECT and turn the jog dial to select “REC”, then press ENTER/NEXT. To change the setting, start over from step 1. To cancel the timer operation Press TIMER SELECT and turn the jog dial to select “TIMER OFF”, then press ENTER/ NEXT. Note If the power is on at the preset time, the recording will not be made. 12 REC SLEEP VOLUME ALL DISCS § Additional Information Additional Information Precautions On operating voltage Before operating the system, check that the operating voltage of your system is identical with the voltage of your local power supply. On safety • The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. • Unplug the system from the wall outlet (mains) if it is not to be used for an extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Never pull the cord itself. • Should any solid object or liquid fall into the component, unplug the stereo system and have the component checked by qualified personnel before operating it any further. • The AC power cord must be changed only at the qualified service shop. On placement • Place the stereo system in a location with adequate ventilation to prevent heat build-up in the stereo system. • Do not place the unit in an inclined position. • Do not place the unit in locations where it is; — Extremely hot or cold — Dusty or dirty — Very humid — Vibrating — Subject to direct sunlight On operation • If the stereo system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player. Should this occur, the system will not operate properly. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. • When you move the system, take out any discs. If you have any questions or problems concerning your stereo system, please consult your nearest Sony dealer. Notes on CDs • Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out. • Do not use solvents such as benzene, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. • Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight. Cleaning the cabinet Use a soft cloth slightly moistened with mild detergent solution. To save a tape permanently To prevent a tape from being accidentally recorded over, break off the cassette tab from side A or B as illustrated. Detector slots Tab of side B Tab of side A Side A Break off the cassette tab of side A If you later want to reuse the tape for recording, cover the broken tab with adhesive tape. However, be careful not to cover the detector sl...
Dieses Handbuch ist für folgende Modelle:Stereoanlage - MHC-GRX8 (987.6 kb)
Stereoanlage - MHC-R800 (987.6 kb)
Stereoanlage - MHC-RX88 (987.6 kb)