Stimmen - 5, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: Kuhn Rikon Dateigröße: 384.42 kb Dateiname: Unterrichtssprache:

DANGER: DO NOT ALLOW OPERATION of this unit by inexperienced and unqualified people. Keep all unqualified people away from mixer during operation. Operators of this unit must be alert and use good judgement at all times. MIXING TIME The Reel Auggie can mix an average load in 3 to 4 minutes. Because of this short mixing time, there is normally no reason to run the mixer during loading except to level the materials or to break up hay. WITH HAY MAXX OPTION: If the hay goes through too fast, you may want to put more material in the mixer before loading the hay or adjust the position of the Hay Maxx to allow more processing (see mixer operation, Hay Maxx adjustments). 3000STOPR005810R082503 MIXER OPERATION Always refer to Operating Safety Precautions and Safety Decal sections of this manual before operating this mixer. MATERIALS NOT REQUIRING PROCESSING Many different kinds of materials can be mixed with the Reel Auggie, but each type has its own unique characteristics. The following feed materials can be efficiently mixed in the Reel Auggie without being processed first : SMALL SQUARE HAY BALES-Dry alfalfa hay can be mixed in rations up to 15%-20% by weight. Always use cured dry hay, Tough hay can cause wrapping, binding and damage to mixer, adversely effect the mixing performance. The following are some examples that contribute to tough hay conditions: High moisture content, High grass content, High density bales, Outdoor storage, Use of hay preservatives and Excessive stem length. For better hay processing in rations with a higher percentage of hay mixing may be improved by pulling the non- wiper cross tubes to the inner setting, (see mixer setup section “reel cross tubes”) this will allow the reel to more aggressively charge the lower auger with hay. FORAGES-Chopped hay, corn silage, and finely chopped crop residue can be mixed in the Reel Auggie. Wet and heavy forages added in large volumes may require more power to mix. GRAINS-Ground, rolled, and whole cereal grains, minerals, and concentrates, are all very easily mixed, and can improve the mixing performance of the other materials. LIQUIDS-Supplements and liquid fat can be blended in the Reel Auggie. Some operators prefer adding liquids into the empty mixer, and others add liquids on top of grains or roughage. Sticky liquids such as molasses tend to increase the power requirements. MATERIALS REQUIRING PROCESSING The following feed materials cannot be efficiently mixed in the Reel Auggie unless they have been broken apart or processed: -ALL LONG AND UNCURED GRASSES -ROUND BALED, LARGE SQUARE BALED, OR STACKED FEEDS The HAY MAXX SYSTEM option should be used to assist in tearing apart long stem hay. HAY PREPARATION Always use cured dry hay. Tough hay can cause wrapping, binding and damage to mixer and can adversely effect the mixing performance. The following are some examples that contribute to tough hay conditions: High moisture content, High grass content, High density bales, Outdoor storage, U...

Herunterladen

Geben Sie zwei Ziffern: