Stimmen - 3, Durchschnittliche Bewertung: 3 ( )

Hersteller: Electrolux Dateigröße: 894.87 kb Dateiname: Unterrichtssprache:

Failure to clean the filter may affect its performance and impair cooking. • Each day wash the stainless steel surfaces with lukewarm soapy water and then rinse and dry thoroughly. • When cleaning stainless steel, never use abrasive tools such as steel wool, wire brushes or scrapers, since they may leave ferrous particles which will promote rusting on the steel surfaces. • If the appliance is not to be used for long periods, proceed as follows: - Disconnect the electrical power supply and close the water valve; - Using a cloth soaked in petroleum jelly, vigorously rub the stainless steel surfaces to apply a light protective film; - Periodically air the place of storage. 7.1 PERIODICAL MAINTENANCE OF THE BOILER • The build-up of lime-scale inside the boiler is signalled by illumination of the LED shown below. When this LED illuminates the boiler must be descaled. The manufacturer declines all liability for failure to clean the boiler when necessary. Moreover, the repair or replacement of scale-damaged parts is not covered by the guarantee if the characteristics of the water supply do not comply with those stipulated (see corresponding paragraph). The boiler may be descaled using either: - pure vinegar (100%); or - a chemical descaler (as instructed below). The oven must be switched on prior to descaling the boiler. 7.1.2 VINEGAR CLEANING METHOD 1) Close the water supply valve. 2) Empty the boiler by pressing the drain button 3) Close the boiler drain after one minute by pressing the above button. 4) Remove the plastic cap from the boiler filler pipe and pour in 8 litres (6-10gn) or 16 litres (20gn) approx. of pure vinegar. 5) Open the water cock. 6) Run a “steam” cycle for 20 minutes. 7) Switch off the oven and wait 60 minutes. 8) Restart the oven in steam mode for a further 10 minutes. 9) Switch off the oven again and wait 60 minutes. 10) With the water cock open, re-open the drain outlet and drain off the vinegar (press the above button). 11) Switch off the oven. 12) Insert a rubber hose inside the boiler filler pipe and rinse thoroughly until the water flowing out of the drain is clear. 13) Refit the filler plug and close the boiler drain (press the above button). 7.1.3 DESCALER CLEANING METHOD If you decide to descale the boiler using a chemical product, follow the directions provided by the product supplier. For example, when using ECOLAB's “STRIP-A-WAY” descaler, proceed as follows: • Follow the instructions given in the previous paragraph and supply the following product quantities via the boiler filler pipe: - 2 litres of descaler liquid plus 6 litres of water (6-10gn). - 4.5 litres of descaler liquid plus 11.5 litres of water (20gn). • Run a “steam” cycle for 12 minutes. • Switch off the oven and wait 40 minutes. • Reopen the boiler drain outlet and proceed as described in the paragraph above. 29 USA 5938 035 01 IMPORTANT - 1 Insert a rubber hose inside the boiler filler pipe and rinse thoroughly with water to remove all traces of descaling agent. • Refit the filler plug and close the boiler drain (by pressing the relative button). After descaling the boiler, it is good practice to execute a 30- minute STEAM cycle with the oven empty. IMPORTANT - 2 If the water supply cock cannot be easily accessed, to empty the boiler proceed as follows: 1) Open the boiler discharge valve with the special pushbutton. 2) Wait 2 minutes and switch the oven off; the discharge valve will close automatically. 7.2...

Herunterladen

Geben Sie zwei Ziffern: