Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
12WE6-00WIFI-10AR USB Cable Connector USB.......... USB..... USB Connector USB.......... USB...... Antenna Connector .......... ...... USB Port USB...... USB.... Antenna Connector .......... ...... GC-WIFI Card GC-WIFI .. USB Cable Connector USB.......... USB..... USB Cable USB..../.. Antenna ..../.. - 2 - Installing the GC-WIFI Card/....GC-WIFI/..GC-WIFI Step 1: Install the GC-WIFI card in a PCI Express x1 slot. Connect one end of the USB cable to the USB connector on the GC-WIFI card. ........ ....GC-WIFI ........PCI Express x1 ............ USB..............GC-WIFI ....USB............ ...: ..GC-WIFI ....PCI Express x1..,... USB.......GC-WIFI ..USB..... .. Step 2: Connect the other end of the USB cable to the F_USB connector on the motherboard. ........ ....USB........................F_USB...... ...: ..USB...........F_USB... Step 3: Tighten the two antenna cables to the antenna connectors on the GC-WIFI card respectively. ........ ..................GC-WIFI .............. ...: .........GC-WIFI ........ Step 4: Then move the antennas to a place where the signal is good. ........ ................................ ...: .................... Step 5: After the computer starts, install the driver for the GC-WIFI card. Adjust your wireless LAN configuration based on your environment after installing the driver. ........ ................GC-WIFI ................................................ ...: ........GC-WIFI ........................ The Wi-Fi Share Utility is for Windows 7 only. ..Wi-Fi Share Utility................Windows 7.. .Wi-Fi Share Utility....Windows 7..... FCC Notice (U.S.A. Only) This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult a dealer or experienced TV/radio technician for help. • Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Neither the Dealer nor the Manufacturer are responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate the equipment. European Community Directive R&TTE Directive Compliance Statement: This equipment complies with all the requirements and other relevant provisions of Directive 1999/5/EC of the European Parliament and the Council of March 9, 1999 on Radio Equipment and Telecommunication Terminal Equipment (R&TTE). This equipment is suitable for home and office use in all the European Community Member States and EFTA Member States. Taiwan Wireless Statements: ........ ...............,....,........................ ............ .........................;.........,.....,... ............ ......,................ ..................................... Declaration of Conformity We, Manufacturer/Importer, G.B.T. Technology Trading GMbH Address: Bullenkoppel 16, 22047 Hamburg, Germany Declare that the product Product Type: PCIe add-in cardProduct Name: GC-WIFIconforms with the essential requirements of the following directives: 2004/108/EC EMC Directive: Conduction & Radiated Emissions:EN55022:2006+A1:2007 Immunity:EN55024:1998+A1:2001+A2:2003 Power-line harmonics:EN61000-3-2:2006 Power-line flicker:EN61000-3-3:1995+A1:2001+A2:2005 2006/95/EC LVD Directive Safety:EN60950-1:2006+A11:2009 1999/5/EC R&TTE DirectiveTechnical Requirements:EN 300 328 v1.7.1 EN 301 489-17 v2.1.12011/65/EU RoHS DirectiveRestriction of use of certain substances in electronic equipment: This product does not contain any of the restricted substances listed in Annex II, in concentrations and applications banned by the directive. CE marking (EC conformity marking) Signature: (Stamp)Date: 10/25/2011Name: TimmyHuangTimmy Huang PCIe add-in card GC-WIFI 10. 25, 2011 Wireless Module Country Approvals/....../....: AustraliaN136United StatesFCC ID: PPD-AR5B95CanadaIC: 4104A-AR5B95BahrainTRA: LIC/0109/N/35ChinaCMIIT ID: 2009DJ0217EcuadorSUPERTEL-2008-000837IndiaWPC ID: ETA-046/2009-RIndonesiaDGPT ID: 10069/POSTEL/2009PLG ID: 1820MexicoRCPATAR09-0168BruneiAITI: DRQ-D-BRUSIN-03-1998-7494-LPD-12586VietnamMIC: A0066140109AE01A2South AfricaTA-2008/1269TaiwanCCAE08LP1590T0European UnionPhilippinesNTCType ApprovedNo.: ESD-0903961CNATIONAL TELECOMMUNICATIONSCOMMISSIONKoreaATH-AR5B950223-0...