Stimmen - 2, Durchschnittliche Bewertung: 3 ( )

Hersteller: Kenwood Dateigröße: 798.03 kb Dateiname: Unterrichtssprache:

Dieses Gerät hat auch andere Anweisungen:

Car-Receiver - KRC-194A (830.3 kb)

Unit Vehicle Ignition cable (Red) A–7 Pin (Red) Battery cable (Yellow) A–4 Pin (Yellow) 3 The A-4 pin (yellow) of the vehicle's ISO connector is not connected to anything, while the A-7 pin (red) is connected to the constant power supply (or both the A-7 (red) and A-4 (yellow) pins are connected to the constant power supply). Unit Vehicle Ignition cable (Red) A–7 Pin (Red) Battery cable (Yellow) A–4 Pin (Yellow) When the connection is made as in 3 above, the unit's power will not be linked to the ignition key. For that reason, always make sure to turn off the unit's power when the ignition is turned off. To link the unit's power to the ignition, connect the ignition cable (ACC...red) to a power source that can be turned on and off with the Installation ¦ Installation Firewall or metal support Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Metal mounting strap (commercially available) Self-tapping screw (commercially available) Screw (M4X8) (commercially available) ignition key. — 23 — 23— 23 — —— English ¦ Removing the 2 When the lower level is removed, remove the upper locations. The frame can be removed from the top side in the same manner. Catch Lock 1 Engage the catch pins locks on the lower level. Lower the frame and pull ¦ Removing the 4 Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. 5 Pull the unit all the way out with your hands, being careful not to drop it. Be careful to avoid injury from the catch pins on the removal tool. 1 Refer to the section remove the hard rubber 2 Remove the screw (M4.8) on the back panel. 3 Insert the two removal tools deeply as shown. Accessory2 Removal tool Accessory2 Removal tool Screw (M4X8) (commercially available) Installation — 24 English ¦ Removing the 2 When the lower level is removed, remove the upper locations. The frame can be removed from the top side in the same manner. Catch Lock 1 Engage the catch pins locks on the lower level. Lower the frame and pull ¦ Removing the 4 Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. 5 Pull the unit all the way out with your hands, being careful not to drop it. Be careful to avoid injury from the catch pins on the removal tool. 1 Refer to the section remove the hard rubber 2 Remove the screw (M4.8) on the back panel. 3 Insert the two removal tools deeply as shown. Accessory2 Removal tool Accessory2 Removal tool Screw (M4X8) (commercially available) Installation — —— Troubleshooting Troubleshooting General ? The power does not turn ON. . The fuse has blown. . After checking for short circuits in the wires, one with the same rating. . No ACC position on vehicle ignition. . Connect the same cable to the ignition as the battery ? If you have selected Standby mode, the power wi...

Herunterladen

Geben Sie zwei Ziffern: