Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Attwood Dateigröße: 458.46 kb Dateiname: Unterrichtssprache:

Splice suitable lengths of brown and black 16-gauge wire to existing pump wiring, enough to reach ON/OFF/ switch and battery. 2. Using insulated terminal connectors, connect positive lead (brown) to the ON/OFF switch. Connect negative lead (black) to ground. 3. In a location easily accessible for changing fuses, splice fuse holder into positive lead (brown). The fuse holder must be installed within 72" (183 cm) of the positive (+) battery terminal. 4. To check system, feed water into the pump. If flow appears to be too low, make sure wires have been connected properly: brown-to-positive (switch), and black-to-negative. Figure 6 LOCK Impeller Pump Chamber• O-Ring• Motor Housing• Locking Button • • CLEANING INSTRUCTIONS 1. To remove the motor housing from base: Depress the locking button and twist motor housing counter-clockwise. 2. Remove three retaining screws that attach pump chamber to motor housing. Remove chamber. 3. Inspect impeller chamber and motor shaft behind impeller. Remove any foreign objects. 4. Inspect “O” ring on lower chamber for nicks, cuts or other damage. Apply a light coat of petroleum jelly to “O” ring surface. 5. Assemble chamber into motor housing. Ensure “O” ring is in retaining groove and alignment pin is in pin receptacle next to locking button. 6. Install and tighten retaining screws. 7. Attach motor housing to pump base by aligning four retaining tabs and twisting clockwise until lock button snaps into place. ATTWOOD HEAVY DUTY BILGE PUMP LIMITED WARRANTY: ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331, (‘Attwood’) warrants to the original consumer purchaser that this Attwood Bilge Pump will be free from defects in materials and workmanship under normal use and service for: Recreational/Pleasure Boats — A period of three (3) years from the date of original consumer purchase. Commercial Boats — A period of one (1) year from the date of original consumer purchase. This warranty does not extend to any batteries or fuses used with the pump. This limited warranty is not applicable if the bilge pump has been damaged by accident, improper installation, unreasonable use, lack of proper maintenance, unauthorized repairs or modifications, or other causes not arising out of defects in materials or workmanship. Attwood’s obligations under this warranty are limited to repair of the product at Attwood’s plant or replacement of the product at Attwood’s option and at Attwood’s expense. Any expenses involved in the removal, reinstallation, or transportation of the product are not covered by this warranty. The product must be returned to Attwood’s plant at the address indicated above postage prepaid, with proof of original purchase including date. If Attwood is unable to replace the bilge pump and repair is not commercially practicable or cannot be timely made, or if the original consumer purchaser is willing to accept a refund in lieu of repair or replacement, Attwood may refund the purchase price, less an amount for de...

Herunterladen

Geben Sie zwei Ziffern: