Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
See or Product Catalog for details. APPLICATION This Attwood Ski Tow is intended for recreational water sport applications only. CAUTION Read all instructions carefully before installing and using this product. WARNING: The Ski Tow is not to be used for watercraft towing, lifting, or for any other anchoring application. Any misuse of the intended application will void the warranty and may result in personal injury and/or damage to the boat. To prevent injury, remove boat from water when installing this product and before using 120V power tools. REQUIRED FOR INSTALLATION • 9/16" deep-socket wrench • 2-1/8" (54mm) hole saw • Cordless drill • Polyurethane marine sealant LOCATION Select an installation location that meets the following criteria: • Ski Tow should be centered on the transom, with the hook vertical and the opening pointing up to accept ski line. To avoid line slipping off the hook, fold it through the end loop to form a knot as shown in Figure 1. • Location on vessel must be able to withstand anticipated loads. • Transom must be a minimum of 3/4" (19mm) thick. • Interior space behind the Ski Tow must be large enough to accommodate the internal 2-1/2"x 5" (64mm x 127mm) Backing Plate. • Access to the interior of the transom is necessary to install the Backing Plate. Figure 1 NOTE: Before you drill or cut a hole in your boat, BE ABSOLUTELY CERTAIN there is room for the Ski Tow and the internal 2-1/2" x 5" (64mm x 127mm) Backing Plate. See Figure 2. 1. Carefully mark center of the hole. 2. Use a 2-1/8" (54mm) hole saw to cut hole for the Ski Tow. See Figure 2. 3. Separate fasteners and Backing Plate from the Ski Tow and set aside. Apply a small bead of marine sealant to the groove under the Ski Tow flange. Place Ski Tow in the hole cutout. 4. Align Ski Tow so the hook is vertical and the opening is up. 5. From inside the transom, fit Backing Plate over the Ski Tow studs. Of the four holes, the two holes in the center will fit on the Ski Tow. 6. Attach fasteners to the Ski Tow studs. Tighten firmly, but do not damage transom or gelcoat by overtightening. Figure 2 2-1/8" (54mm.) Dia. Backing Plate Washers Locking Nuts Apply Marine Sealant ATTWOOD LIMITED LIFETIME WARRANTY ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331 (“Attwood”) warrants to the original consumer purchaser that, under normal use and service, this Attwood brand product will be free from defects in materials and workmanship for the service life of the vessel on which it is originally installed. This limited warranty is not applicable if the product has been damaged by accident, improper installation, unreasonable or improper use, lack of proper maintenance, unauthorized repairs or modifications, normal wear and tear, or other causes not arising out of defects in materials or workmanship. Attwood products are warranted for use on pleasure boats. Any other use - including but not limited to commercial, racing, or non-marine use - are not cov...
Dieses Handbuch ist für folgende Modelle:Motorboote - 69371 (129.49 kb)