Stimmen - 4, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Braun Dateigröße: 285 kb Dateiname: Unterrichtssprache:

Otherwise steam can develop when pouring cold water into the water tank which might cause scalding. Your Braun FlavorSelect coffeemaker is designed to use any filter size 4. However, only Braun reusable filters designed for the FlavorSelect series will fit properly. Caution – other brand reusable filters may not be properly sized to your Braun FlavorSelect coffeemaker. Maximum cups KF 140, KF 145 – 10 cups (0.125 l / 4.4 fl. oz per cup) KF 152, KF 157 – 12 cups (0.125 l / 4.4 fl. oz per cup) Description 1 2 3 4 4a 4b 5 6 7 8 9 10 10a 10b Cord storage Water level indicator Tank Space compensator Water filter cartridge (only with KF 145 and KF 157 models) Dial for water filter exchange Flavor selector (mild taste = / robust taste = ) Tank cover Filter support bracket Filter basket Hotplate On/off switch – KF 140 and KF 152 (with red pilot light) On/off switch – KF 145 and KF 157 (with red pilot light) Cups selector – KF 145 and KF 157 (with yellow pilot light) Filling with coffee grounds Swing out the filter basket 8 (a) and insert a No. 4 filter. Put coffee grounds (not ground too finely) into the filter. Measure coffee grounds according to the strength desired. Close the filter basket again (a), letting it snap in place. ————————————————————————— Permanent filters Gold or gold-screen filters which may be used instead of paper filters are available as accessories. Please, note the following: Your coffee grind should be medium; a very fine grind could cause the filter to overflow. Put the ground coffee into the center of the filter and prepare your coffee as described. For cleaning rinse the filter under running water. After using it for some time, clean with a soft brush or a soft sponge – do not use abrasive cleansers or pads. The gold filter and the gold-screen filter can be washed in the dishwasher. ————————————————————————— Filling with water Important: When filling with water and during coffee preparation either the space compensator 4a 4 or the water filter cartridge have to be installed in the water tank 3 . Otherwise the water level indicator will not function correctly and the carafe may overflow. Pour cold water into the tank 3 to the number of cups of coffee desired. To do this, lift the tank cover and pour the cold water into the tank. The amount of water is shown on the water level indicator 2 (KF 140, KF 145 – maximum 10 cups; KF 152, KF 157 – maximum 12 cups). Pre-selecting the taste – flavor selector By adjusting the flavor selector 5 , you can adjust the taste of your coffee to suit your personal preference – milder with less bitter aftertaste or stronger, but always with the same full flavor. Set the flavor selector under the tank cover before turning on the coffee- maker. If you prefer milder coffee with less bitter aftertaste, turn the flavor selector 5 in the direction of the symbol (b). Should you prefer a more robust taste, turn the flavor selector towards the symbol. Regardless of the position you select, the coffee will always have the same full flavor. Controls Flavor selector Mild taste = Robust taste = 5 On/off switch 10 – KF 140, KF 152 On = (the red pilot light is on) Off = On/off switch 10a – KF 145, KF 157 On = (the red pilot light is on) Off = The red pilot light lights up when the coffeemaker is switched on; it goes out when the appliance is switched off. Cups selector 10b – (KF 145, KF 157) min-3 (cups): Even small quantities (to 3 cups) will maintain the right temperature and flavor. The yellow pilot light lights up. 4-max (cups): Larger quantities (4 and more cups) will maintain the right temperature and flavor. Making coffee Place the carafe with the lid onto the hotplate 8 9 and snap the filter basket in place. Switch the coffee- maker on (see on/off switch). Brewing time is approx. 50 seconds per cup (including dripping). The pause and serve feature allows you to pour a cup in mid- brewing cycle and prevents coffee from dripping on the hotplate when removing the carafe from the hotplate. The brewing, however, continues when the pause and serve feature is activated. The carafe should be immediately returned to the hotplate after pouring to prevent the filter basket from overflowing. To make coffee, the carafe with the lid snapped on (d) must be set on the hotplate 9 and the filter basket 8 must be snapped in place (a). Due to a built-in overflow protection feature, the liquid in the filter will flow directly into the carafe if you forget to snap the filter basket in place or put the lid on. The carafe must be on the hotplate for the overflow protection to work. Remove the filter basket 8 to empty grounds (see «Cleaning»). Keeping the coffee hot The carafe rests on the hotplate 9 which begins to heat up when the coffeemaker is switched on and will keep the coffee hot until the coffeemaker is switched off (red pilot light goes out). KF 145, KF 157: If you want to keep more than 4 cups of coffee hot, set the cups selector 10b to position 4-max, or less than 4 cups to posit...

Herunterladen

Geben Sie zwei Ziffern: