Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
BRACKET A BURNER PORTS NOTE: INSTALL REAR BURNER FIRST, THEN FRONT BURNER. MILLIVOLT Thermocouple Hood Ignitor Rod ..." Min (9 mm) Thermopile Pilot Nozzels WARNING: THIS APPLIANCE IS NOT DESIGNED TO BURN WOOD. ANY ATTEMPT TO DO SO COULD CAUSE IRREPARABLE DAMAGE TO YOUR APPLIANCE AND PROVE HAZARDOUS TO YOUR SAFETY. WARNING: THE SIZE AND POSITION OF THE LOG SET WAS ENGINEERED TO GIVE YOUR APPLIANCE A SAFE, RELIABLE AND ATTRACTIVE FLAME PATTERN. ANY ATTEMPT TO USE A DIFFERENT LOG SET IN THE FIREPLACE WILL VOID THE WARRANTY AND WILL RESULT IN INCOMPLETE COMBUSTION, SOOTING, AND POOR FLAME QUALITY. WARNING: LOG SET GETS VERY HOT AND WILL REMAIN HOT UP TO ONE HOUR AFTER GAS SUPPLY IS TURNED OFF. HANDLE ONLY WHEN LOG SET IS COOL. TURN OFF ALL GAS TO THE APPLIANCE BEFORE INSTALLING THE GRATE AND LOG SET. Electronic Appliance Checkout Electronic Appliance Checkout tions on page 14 and 15. Ensure the ignitor lights the pilot. The pilot flame should engulf the flame sensor as shown in Figure 10 Figure 10 Proper Flame Adjustment Hot Surface Igniter Flame Rod Ground Electrode 3/8 To 1/2 Inch (9 mm to 13 mm) With proper care and maintenance, your appliance will provide many years of enjoyment. If you should experience any problem, first refer to the trouble shooting guide in this manual. If problem persists, contact your Lennox distributor. WIRING DIAGRAMS Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics attached directly to the appliance on a pullout panel located within the control compartment. CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS APPLIANCE OPERATION. WARRANTY Your gas appliance is covered by a limited twenty year warranty. You will find a copy of the war- ranty accompanying this manual. Please read the warranty to be familiar with its coverage. Millivolt Wiring Diagram If any of the original wire as supplied must be replaced, it must be replaced with Type AWM 105°C, 18 GA. wire. Thermopile THTP TH TP *TWIST WIRES “A” AND “B” TOGETHER TO OPERATE UNIT SOLELY BY MANIPULATING THE GAS VALVE CONTROL KNOB; OR CONNECT WIRES TO OPTIONAL UNIT-MOUNTED ON/OFF SWITCH OR WALL-MOUNTED ON/OFF SWITCH OR THERMOSTAT TO OPERATE UNIT. *UNIT-MOUNTED ON/OFF SWITCH (Accessory Option) OR WALL-MOUNTED ON/OFF SWITCH (Accessory Option) OR THERMOSTAT (Accessory Option) OR REMOTE CONTROL RECEIVER (Accessory Option) A B NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS A complete parts list is found at the end of this manual. Use only parts supplied from the manufacturer. Normally, all parts should be ordered through your Lennox distributor or dealer. Parts will be shipped at prevailing prices at time of order. When ordering repair parts, always give the following information: PRODUCT REFERENCE INFORMATION We recommend that you record the following important information about your fireplace. Please contact your Lennox dealer for any...
Dieses Handbuch ist für folgende Modelle:Kamine - NEC-FPDC (1.49 mb)
Kamine - NEC-FPDC (1.49 mb)
Kamine - NEC-FPDC (1.49 mb)
Kamine - NEC-LCDC (1.49 mb)