Stimmen - 5, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: Monessen Hearth Dateigröße: 973.7 kb Dateiname: Lennox_Hearth_D400_Installation_700020M.pdf Unterrichtssprache:

page 26 This installation manual will help you obtain a safe, efficient, dependable installation for your appliance and vent system. Please read and understand these instructions before beginning your installation. PACKAGING The assembled vented gas fireplace heater is packaged with: 1 -one log set shrink-wrapped to the in side surface of the front glass enclosure panel. 2 -one plastic bag containing the literature package which consists of the homeowner's care and operation instructions, installation instructions and warranty; plastic bag located in the control area. 3 -one vent restrictor for use in top vent applications; restrictor is taped to the inside of the cabinet bottom. 4 -one hood wrapped in plastic taped to the front of the top unit standoffs. 5 -one bag of glowing embers located in the control area. INTRODUCTION These vented gas fireplace heaters are sealed combustion, air circulating gas fireplaces designed for residential applications. These appliances must be installed with the Secure Vent™ and /or Secure Flex™ vent systems routed to the outside atmosphere. Millivolt appliances are designed to operate on natural or propane gas. A millivolt gas control valve with piezo ignition system provides safe, efficient operation. External electrical power is required to operate the optional blower if installed in these units. Electronic appliances are designed to operate on natural or propane gas. An electronic intermittent pilot ignition system provides safe, efficient operation. External electrical power is required to operate these units. These millivolt and electronic versions of these appliances are listed by Omni Test Laboratories for installation in bedrooms and mobile homes. Installation must conform to local codes. In the absence of local codes, installation must comply with the current National Fuel Gas Code, ANSI Z223.1. (In Canada, the current CAN-1 B149 installation code.) Electrical wiring must comply with the National Electrical Code ANSI/ NFPA 70 - (latest edition). (In Canada, the current CSA C22-1 Canadian Electrical Code.) DO NOT ATTEMPT TO ALTER OR MODIFY THE CONSTRUCTION OF THE APPLIANCE OR ITS COMPONENTS. ANY MODIFICATION OR ALTERATION MAY VOID THE WARRANTY, CERTIFICATION AND LISTINGS OF THIS UNIT. GENERAL INFORMATION Note: Installation and repair should be performed by a qualified service person. The appliance should be inspected annually by a qualified professional service technician. More frequent inspections and cleanings may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that the control compartment, burners and circulating air passage ways of the appliance be kept clean. S'assurer que le bruleur et le compartiment des commandes sont propres. Voir les instructions d'installation et d'utilisation qui accompagnent l'appareil. Provide adequate clearances around air openings and adequate accessibility clearance for service and proper operation. Never obstruct the front openings of the appliance. These appliances are designed to operate on natural or propane gas only. TYPICAL INSTALLATION Figure 1 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Millivolt Models Millivolt Models Millivolt Models with Manually-Modulated Gas Valve Natural and Propane Gas Model Numbers Input rate (BTU/H) DT-400 DR-400 13,500 to 17,500 Electronic Models Electronic models have a fixed rate gas valve. Input of electronic models is shown in the following table: Electronic Models with Fixed-Rate Gas Valve Natural and Propane Gas Model Numbers Input rate (BTU/H) DT-400 DR-400 17,500 All Models Maximum manifold pressure is 3.5 in. w.c. (0.87 kPa) for natural gas and 10 in. w.c. (2.49 kPa) for LP/Propane gas. Installations at Altit...

Herunterladen

Geben Sie zwei Ziffern: