Aluminum w/Cast Iron Sleeve Valve Arrangement.............................................................................................. ................................................. Overhead Valve Ignition System.................................................................................................... ............................................ Solid-state w/Magneto Governor System..............................................................................................

and Canadian Standards FEATURES USTED □ INNOVATIVE DESIGN & PROTOTYPE TESTING are key components of CARRIER'S success in “IMPROVING POWER BY DESIGN.” But it doesn't stop there. Total commitment to component testing, reliability testing, environmental testing, destruction and life testing, plus testing to applicable CSA, NEMA, EGSA, and other standards, allows you to choose CARRIER with the confidence that these systems will provide superior performance. □ TEST CRITERIA: ✓ PROTOTYPE TESTED

NOTE: Any piping used to connect the generator to the fuel supply should be of adequate size to ensure the fuel pressure NEVER drops below 4 inches water colum for natural gas or 10 inches water column for liquid propane for all load ranges. 1.8 FUEL CONSUMPTION *Natura{ gas is in cubic feet per hour. **LP is in gatlons per hour/cubic feet per hour. **_ Values given are approximate Model # Nat. Gas (*) LP Vapor (**) 1/2 Load FullLoad 1/2 Load Full Load 6/7 kW 66 119 O.82/30 1.47/54 12 kW 152 215

OHFHter 3.4 CHANGING THE OIL FILTER Change the engine oil filter as follows: 1. With the oil drained, remove the old oil filter by turning it counterclockwise. 2. Apply a light coating of clean engine oil to the gasket of the new filter. See Section 1.5.2 for recommended filter. 3. Screw the new filter on by hand until its gasket lightly contacts the oil filter adapter. Then, tighten the filter an additional 3/4 to one turn (Figure 3.4). 4. Refill with the proper recommended oil (see Section 3.3

DEADLY EXHAUST FUMES. OUTDOOR INSTALLATION ONLY!! INTRODUCTION Thank you for purchasing this model of the Carrier product line. This model is a compact, high performance, air-cooled, engine-driven generator designed to automatically supply electrical power to operate critical loads during a utility power failure. This unit is factory installed in an all-weather, metal enclosure that is intended exclusively for outdoor installation. This generator will operate using either vapor withdrawn liquid

A_ intended for outdoor installation only. A_ Not intended for life support applications. c_0s LISTED ELECTRICALINTERCONNECTIONDRAWING ® Turn to the Expertg \ \ \ N1 N2 23 194 / I GENERATOR GROUND \ / (LOCATED ON THE REAR OF UNIT) \ \ / GENERATOR OUTPUT CIRCUmT BREAKER 2 POLE \ / / / \EARTH \ SPIKE "_ \ \ \ \ TO HOUSE BRANCH CiRCUiTS SPLICED USING WiRE NUTS EMERGENCY CiRCUiTS IllU 40A OR 70A 2-POLE CIRCUIT BREAKER i BAR SERVICE CONNECTION BOX EXTERNAL CUSTOMER (8,10,12 UL LISTED PANEL BOARD OR 1