Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Generac Dateigröße: 846.53 kb Dateiname: 97600.pdf Unterrichtssprache:

Remove all rings, watches and other jewelry. This machine should be grounded in accordance with all local electrical codes. Consult the local electrical codes or Authority Having Jurisdiction in the area where the machine will be used for specific requirements. Collision Hazard Check the work area for overhead obstructions or other possible hazards. Bodily Injury Hazard Do not grasp the cable. Use proper lifting techniques when lifting and positioning the tongue of the machine. Always replace the protective lamp cover after replacing the lamp bulbs. SAFETY RULES Burn Hazard Do not touch the lamp fixtures while they are turned on. Turn the lamps off and allow them to cool before touching. Crushing Hazards Do not lower the mast unless the area below is clear of personnel and obstructions. Do not release the spring latch on the side of the machine unless the mast sections are fully retracted. Keep hands and fingers away from any potential pinch points. Damaged Machine Hazards Do not use a damaged or malfunctioning machine. Do not use a machine with a worn, frayed, kinked or damaged cable. Be sure the operator's manual is complete, legible and in the storage container located on the machine. Be sure all decals are legible and in place. Part No. 97600 Genie TML-4000 and TML-4000N Operator's Manual Third Edition • Second Printing SAFETY RULES Explosion and Fire Hazards Do not start the engine if you smell or detect diesel fuel or other explosive substances. Do not refuel the machine with the engine running. Refuel the machine and charge the battery only in an open, well-ventilated area away from sparks, flames and lighted tobacco. Do not operate the machine in hazardous locations or locations where potentially flammable or explosive gases or particles may be present. Keep sparks, flames and lighted tobacco away from the battery. Batteries emit an explosive gas. Do not spray ether into the engine. Component Damage Hazards Do not turn the lights on unless the engine is running. Always turn the lights off before shutting down the engine. Do not use any battery charger greater than 12V to charge the battery. Do not expose the battery or the charger to water or rain. Do not replace lamp bulbs with any bulbs other than those specified on the machine and in this manual. Improper Use Hazard When leaving the machine unattended, secure from unauthorized use. Unauthorized personnel may attempt to operate the machine without proper instruction, creating an unsafe condition. Towing Hazards Read, understand and obey all of your tow vehicle manufacturer’s recommendations, warnings and instructions before towing this machine. Do not tow the machine unless the mast is lowered to the horizontal position and is properly stowed in the transport cradle. Do not tow the machine unless the mast hold-down latch is securely locked in place. Do not overload your tow vehicle. Check the manufacturer's Gross Vehicle Weight Rating (GVWR). To obtain the gross vehicle weight, add the tongue weight of the trailer to the vehicle weight (including vehicle, passengers and cargo). Do not load cargo on the machine. The TML is not designed to carry any extra cargo. Be sure the hitch is securely attached to the tow vehicle. Be sure the safety chains (if required) are securely attached to the tow vehicle. Be sure that all driving lights are operational. Be sure all hitch components, lights and mirrors and methods of attaching the trailer to the tow vehicle conform to local, state and federal regulations. Do not tow the machine on public roads unless it meets all governmental regulations for towing. Do not exceed 60 mph / 97 km/h. Obey all local and national towing speed laws. Be sure to chock the wheels of the trailer when parking on a hill. Genie TML-4000 and TML-4000N Part No. 97600 Third Edition • Second Printing Operator's Manual SAFETY RULES Decal Legend Genie product decals use symbols, color coding and signal words to identify the following: Safety alert symbol—used to alert personnel to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Red—used to indicate the presence of an imminently hazardous situation which, if not avoided, will result in death or serious injury. Orange—used to indicate the presence of a potentially hazardous situation which, if not avoided, could result in death or serious injury. Yellow with safety alert symbol— used to indicate the presence of a potentially hazardous situation which, if not avoided, may cause minor or moderate injury. Yellow without safety alert symbol—used to indicate the presence of a potentially hazardous situation which, if not avoided, may result in property damage. Green—used to indicate operation or maintenance information. Part No. 97600 Genie TML-4000 and TML-4000N 6 Genie TML-4000 and TML-4000N Part No. 97600 Operator's Manual Third Edition • Second Printing 1 Outrigger leveling jack with footpad 2 Outrigger jack handle 3 Outrig...

Herunterladen

Geben Sie zwei Ziffern: