Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
What is Eco Max mode? How does this mode
Why does the parent unit beep?
help the environment?
• If the parent unit beeps while the ‘link’ light
• The Eco Max mode has been developed to
flashes red continuously and the message ‘NOT
enable you to reduce the energy consumption
LINKED’ or ‘LINKING’ is shown on the display,
of your baby monitor. When you monitor your
the connection with the baby unit is lost. Move
baby from a small distance, you can activate the
the parent unit closer to the baby unit or switch
Eco Max mode. By switching on the Eco Max
the baby unit on, if it was off.
mode, your baby monitor uses less energy and
• If the parent unit beeps and the battery symbol
is therefore more environment-friendly.
on the display is empty, the rechargeable
batteries of the parent unit are running low.
Why don’t the power-on light of the baby unit
Recharge the batteries.
and the ‘link’ light of the parent unit come on
• If you have set the room temperature range on
when I press the on/off buttons of the units?
the parent unit and the temperature alert is on,
• Perhaps the rechargeable batteries of the
the parent unit beeps when the temperature
parent unit are empty and the parent unit is not
drops below the set minimum temperature
plugged in. Insert the small appliance plug into
range or when the temperature rises above the
the parent unit and put the adapter in a wall
set maximum temperature range.
socket. Then press the on/off button to establish • The baby unit may be switched off. Switch on
connection with the baby unit.
the baby unit.
• Perhaps the non-rechargeable batteries of the
baby unit are empty and the baby unit is not
Why does the appliance produce a high-pitched
connected to the mains. Replace the non-
noise?
rechargeable batteries or connect the baby unit
• The units may be too close to each other. Make
to the mains. Then press the on/off button to
sure the parent unit and the baby unit are at
establish connection with the parent unit.
least 1 metre/3.5 feet away from each other.
• If the ‘link’ light on the parent unit still does not
• The volume of the parent unit may be too high.
start flashing red, use the reset function to reset
Decrease the volume of the parent unit.
the units to their default settings.
Why don’t I hear a sound/Why can’t I hear
Why does the ‘link’ light on the parent unit flash my baby cry?
red continuously and why is the message ‘NOT
• The volume of the parent unit may be too low
LINKED’ or ‘LINKING’ shown on the display?
or may be switched off. Increase the volume of
• The baby unit and the parent unit are out
the parent unit.
of range of each other. Move the parent unit
• The microphone sensitivity level of the baby
closer to the baby unit.
unit may be too low. Set the microphone
• The baby unit may be switched off. Switch on
sensitivity level to a higher level in the menu of
the baby unit.
the parent unit.
• The baby unit and the parent unit may be out
Why does the battery status light on the baby
of range of each other. Reduce the distance
unit flash red?
between the units.
• The non-rechargeable batteries of the baby unit
are running low. Replace the non-rechargeable
batteries or connect the baby unit to the mains
(see chapter ‘Preparing for use’).
20
...