Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Eaton Electrical Dateigröße: 274.8 kb Dateiname: ef2eee89-4f3c-484d-82c8-34a5d22a0ff4.pdf Unterrichtssprache:

Speaker cable should be run to each speaker location prior to speaker installation. In new construction applications, run the speaker wire to the speaker locations prior to drywalling. Speaker Grill Removed From Frame Choosing the Speaker Location Before you install your speakers you should carefully consider their location to ensure the best quality sound. Make sure to note the location of lighting fixtures, electrical wiring, plumbing, HVAC ducting, or any other possible obstructions. Once you have selected the area for installation, locate the studs or joists nearest to the desired location. By marking the location of the stud or joist first, you can avoid cutting into it as you cut the speaker hole. A speaker cutout template is included to help you measure cutout dimensions. Position the template into the desired location and outline the speaker opening. If you are still not sure of possible obstructions, cut a small hole in the center of your mounting location. This small hole will allow you to check for obstructions behind the surface prior to cutting out the entire speaker hole. If there are no problems with your mounting location, proceed to cut out the outlined hole. If the area where the speaker will be placed is not already insulated, Eaton suggests adding insulation, Dacron, or some other sound dampening material. If you add insulation with a foil layer, make sure to mount the foil side away from the speaker magnet. Ceiling Placement Speakers placed into the ceiling should be mounted above or as close to the listening area as possible. Take furniture arrangements into consideration when finalizing your speaker locations. The tweeters located in the speakers can be adjusted to point towards the listening area of the room. Speaker Installation Note: Speaker cable should be run to each speaker location prior to speaker installation. In new construction applications, run the speaker wire to the speaker locations prior to drywalling. To Install Remove speaker grill first. Locate the mounting brackets on the rear of the speaker. Mounting Bracket Locked In Mounting Brackets on Rear of Speaker (Locked In) Twist the mounting brackets out of their locked position so they can slide down the open channel. Mounting Bracket Unlocked Out Mounting Brackets on Rear of Speaker (Unlocked Out) Push the brackets down the slide channel towards the front of the speaker, holding onto the speaker frame for support. Push Down on the Mounting Brackets to Pop-Off the Speaker Grill Once the mounting brackets are pushed down, the grill will release from the frame. Pushing Down on the Legs of the Mounting Bracket Releases the Speaker Grill From the Frame Positive Negative Speaker Rear View Consisting of a Positive and Negative Wire Set Next, attach the speaker wire from mounting location to the back of the speaker. Caution: Make sure to observe polarity (positive + to positive + and negative – to negative -). Finally, to mount the speaker, turn all the mounting bra...

Herunterladen

Geben Sie zwei Ziffern: