Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Hobart Dateigröße: 101.05 kb Dateiname: 98a1cf20-acd0-4d44-be28-779a93717966.pdf Unterrichtssprache:

Keep in mind that: The oven should be located under a hood which has an adequate connection to an exhaust duct and extends 6" (152.4mm) beyond the oven sides. Clearance above the oven flue should be adequate for the flue products to escape so that there is no interference with the heat circulation in the ovens. Ovens may use an optional down draft diverter flue method. This optional down draft diverter must be purchased from the oven manufacturer and vented to the outside; otherwise, the installation of any such device will void all oven certifications and warranties. When the diverter is supplied, it may be connected to a Type “B” vent. BEFORE FIRST USE Before using the oven for the first time, it must be "burned in" to release any odors that might result from heating the new surfaces in the chamber. Using a clean damp cloth, wipe the inside of the oven, including the racks. Close the oven doors, turn the ON/OFF/COOLDOWN switch ON, turn the thermostat to 300°F (149°C) and allow the oven to cycle for 6 to 8 hours before turning the switch OFF. – 9 – OPERATION CONTROLS — MODELS DGC1 & HGC40/HGC60 (Fig. 4) ON HEAT IGNITION ONPOWER OFF COOL DOWN ON OFF HI LO FAN LIGHTS ON OFF GAS VALVE TO LIGHT OVENPLACE ON/OFF/COOL DOWNSWITCH IN "ON" POSITION. IF OVEN FAILS TO LIGHTRETURN ON/OFF/COOL DOWNSWITCH TO "OFF". ALLOW5 MINUTES FOR RETRIAL. TO SHUT-OFF OVENPLACE ON/OFF/COOL DOWNSWITCH IN "OFF" POSITION. COOK TEMPERATURE OFF F 450 400 350 250300 500 COOK TIME 40455055 253035 20 15 5 10 60 0 OFF ON/OFF/COOL DOWN SWITCH FAN SWITCH LIGHT SWITCH ON LIGHT HEAT LIGHT NO IGNITION LIGHT THERMOSTAT TIMER GAS VALVE PL-51602 COOK TEMPERATURE 425450 475 400 350 300 250 225 150 300 500 TEMPF 4045 50 55 253035 20 15 5 10 60 0 OFF ON HEAT IGNITION ONPOWER OFF COOL DOWN ON OFF HI LO FAN LIGHTS ON OFF GAS VALVE TO LIGHT OVENPLACE ON/OFF/COOL DOWNSWITCH IN "ON" POSITION.TO SHUT-OFF OVENPLACE ON/OFF/COOL DOWNSWITCH IN "OFF" POSITION. COOK TIME ON/OFF/COOL DOWN SWITCH FAN SWITCH LIGHT SWITCH ON LIGHT HEAT LIGHT NO IGNITION LIGHT THERMOSTAT TIMER GAS VALVE PL-51603 MODEL DGC1 MODEL HGC40/HGC60 Fig. 4 ON / OFF / COOLDOWN SWITCH — ON — turns oven control circuits on. OFF — turns oven control circuits off. COOLDOWN — allows the fan motor to run with the doors ajar to speed oven cooling. 2-SPEED FAN SWITCH — HI / LO — Adjusts air velocity in the oven. LIGHT SWITCH — ON / OFF — Turns lights in the oven on or off. THERMOSTAT — Controls oven temperature during cooking operation. TIMER — Use to set cooking cycle time. Alarm sounds continuously when elapsed time counts down to 0; oven does not turn off. Turn timer to OFF position to stop alarm. When oven is not in use, keep timer at OFF position. ON LIGHT (Amber) — Lit when the ON/OFF/COOLDOWN switch is positioned at ON or COOLDOWN. HEAT LIGHT (White) — Comes on and goes off when the burner cycles on and off. NO IGNITION LIGHT (Red) — Comes on if burner fails to ignite after the third try. When lighting oven, the NO IGNITION LIGHT cycles ON during the 5-second purge and OFF during 7-second ignition trial. GAS VALVE — When ON, allows gas to flow to the ignition system. – 10 – LIGHTING THE DGC1 AND HGC40/HGC60 OVENS Turn manual gas valve ON. Turn ON/OFF/COOLDOWN switch ON and turn thermostat to its maximum setting. Both the ON and HEAT lights should come on. If HEAT light is not on, make sure door is closed. After 5 seconds, the spark ignition system will start and the solenoid valve will open, allowing gas to flow to the burner for 7 seconds. This 5-second purge and 7-second ignition trial will repeat up to two more times if the burner does not light within the first 7-second ignition trial. During this 5-second prepurge, the red NO IGNITION light will be lit. When the burner gas ignites, a slight "roar" will be heard. This "roar" is a normal condition of the power burner and will become almost undetectable in the normal operating mode after warm-up. The NO IGNITION light will go off when ignition occurs. If the burner fails to light after three trials, the red NO IGNITION light will be lit and remain on. Turn ON/OFF/COOLDOWN switch OFF for five minutes before repeating lighting sequence previously described. If the burner does not light after three trials, turn off the manual gas valve and call a qualified servicer. USING THE DGC1 AND HGC40/HGC60 OVENS Preheating 1. Turn ON/OFF/COOLDOWN switch ON. The amber ON light will come on, indicating that power to the oven is on. 2. Set THERMOSTAT as desired. Refer to COOKING GUIDELINES for suggested temperatures and times for various products. 3. Prepare product and place in suitable pans. When the white HEAT light goes off, the oven has reached desired preheat temperature. Cooking 1. Open doors and load the product into the oven. Place pans in the center of the racks. Close doors. 2. Set the TIMER. After the preset time lapses, turn timer to OFF position to stop the buzzer. 4. When product is done, open doors and carefully remove cooked product from the ov...

Herunterladen

Geben Sie zwei Ziffern: