Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
etc. to make it rigid so it does not move during the work -The tool is not electrically insulated. Never use the tool if operation. Keep good balance at all times. Do not stretch there is any chance of coming into contact with live or overreach. electricity. -Try to match the tool to the work operation. Do not use a -Always when using the tool, adopt a firm footing and/or tool that is too light or heavy for the work operation. If in position and rip the tool sufficiently only to overcome doubt, seek advice. any reaction forces that may result from the tool doing -In general terms, this tool is not suitable for underwater work. Do not overgrip. use or use in explosive environments -seek advice from -Use only correct spare parts for maintenance and repair. manufacturer. Do not improvise or make temporary repairs. Major -Try to make sure that the work area is clear to enable the servicing and repairs should only be carried out by work task to be performed safely. If practical and persons trained to do so. possible, try to clear unnecessary obstructions before -Do not lock, tape, wire, etc. the 'OnIOff' valve in 'On' starting work. position.The throttle tri gertlever, etc. must always be free -Always use air hose and couplings with minimum work- to return to the '6ft' position when released. ing pressure ratings at least 1 112 times the maximum -blwa s shut off the air supply to the tool and press the working pressure rating of the tool. On/8ff1 valve to exhaust the air from the feed hose before fitting, removing or adjusting the workina attachment fitted to the tool. Take Air From Top -~eforeusingthe tool, make sure that a All Pipe And Fittings shut off device has been fitted to the , Should Be 112"Or Larger supply line and the position is known Compressor and easily accessible so that the air with Sufficient Capacity supply to the tool can be shut off in an To Maintain Recommended 11 11 11 emergency. Workina Pressure At 11 11 -Check hose and fittings regularty for wear. -Take care against entanglement of the moving parts of the tool with clothing, hair, ties, cleaning rags, rings, jewelry, watches, bracelets, etc. This could cause the body or parts of the body to be drawn towards and in contact with the moving parts of the tool and could be very dangerous. -It is expected that users will adopt safe 1 Recommended Air Supply System Figure 1 working practices and observe all Page No 1 ...
Dieses Handbuch ist für folgende Modelle:Häcksler - 5264 (343.53 kb)