Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Electrolux Dateigröße: 817.47 kb Dateiname: Unterrichtssprache:

(page 6) 15. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. 16. Do not tilt lawnmower when starting the engine 17. Do not put hands near the grass discharge chute whilst engine is running. 18. Never pick up or carry a lawnmower while the engine is running 19. Spark plug wire may be hot - handle with care. 20. Do not attempt any maintenance on your lawnmower when the engine is hot. 21. Release the Operator Presence Control, to stop the engine, and wait until the blade has stopped:- before leaving the mower unattended for any period; 22. Release the Operator Presence Control, to stop the engine, wait until the blade has stopped, disconnect the spark plug lead and wait until the engine has cooled:- before refuelling - before clearing a blockage; -before checking, cleaning or working on the appliance; - if you hit an object. Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition.; -if the lawnmower starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury. 23.Reduce the throttle setting during engine shut down and, if the engine is provided with a shutoff valve, turn the fuel off at the conclusion of mowing. Maintenance and storage 1. Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition. 2. Check the grassbox/grassbag frequently for wear or deterioration. 3. Replace worn or damaged parts for safety. 4. Only use the replacement blade, blade bolt, spacer and impeller specified for this product. 5. Never store the lawnmower with fuel in the tank inside a building where fumes can reach an open flame or spark. 6. Allow the engine to cool before storing in any enclosure. 7. To reduce fire hazard, keep the engine, silencer, battery compartment and fuel storage area free of grass, leaves or excessive grease. 8. If the fuel tank has to be drained, this should be done outdoors. 9. Be careful during adjustment of the machine to prevent entrapment of the fingers between the blade and fixed parts of the machine. ASSEMBLY INSTRUCTIONS WHEEL ASSEMBLY (WHERE NECESSARY) 1. Select one of the holes in the mounting plate and note its position, as all four wheels will need to be adjusted to the same position (A1). 2. Locate the fixing bolt through hole in hub cap, wheel and selected hole in mounting plate. HANDLES Lower Handles 1. If your product has Cutting Height with levers (see Adjustment, page 5), ensure the lever is at the Highest Cut Height before following steps 2 & 3. 2. Insert each side of the lower handle into deck as shown in Fig B1. 3. Push each side of the handle firmly down until it is located securely into the deck (B2). 4. Insert screw through the washer and into holes using a pozidrive screwdriver and tighten fully into deck as shown in Fig B2. 3. Turn the wheel hub in a clockwise direction until the wheel assembly is securely located to the deck (A2). Upper Handles 1. Fit the upper handle to the lower handle with the bolts, washers and handle knobs. (C1) 2. Fit the cables to the handles with the cable ties provided, making sure the cables are not trapped between the upper and lower handles. Handle Adjusters fitted to product 1. Adjust handle assembly to the most comfortable operating position and tighten handle adjuster knob (C2) on both sides of the product. ENGLISH - 2 ASSEMBLY INSTRUCTIONS RECOIL STARTER • You must release the brake by pulling the OPC 3. Extend the pul...

Herunterladen

Geben Sie zwei Ziffern: