Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: FUNAI Dateigröße: 1.69 mb Dateiname: VV1300.pdf Unterrichtssprache:

Used properly, it will bring you and your family years of enjoyment. Please fill in the information below. The serial number is on the tag located on the back of your unit. Date of Purchase Dealer Purchased From Dealer Address_ Dealer Phone No__ Model No__ Serial No__ А АЛ Л И1Л JN ICO AC *10* f VOL p О 'OfO HOG 5 t О <ОгО □ Remote Control LSSQ0223 (VV-1300/VV-2000) LSSQ0227 (VV-1310) □ Batteries 2 “AA” To order accessories, call toll free 1-800-332-5368. Record/Playback Time Only use tapes with the IVHSI mark in this unit. Tape Speed Setting Type of Video Cassette T60 T120 T160 SP (Standard Play) 1 Hour 2 Hours 2 Hours 40 Minutes LP (Long Play) 2 Hours 4 Hours 5 Hours 20 Minutes SLP (Super Long Play) 3 Hours 6 Hours 8 Hours Loading the Batteries 1) Open the cover. 3) Close the cover. □ Battery replacement caution • Do not mix old and new batteries. • Do not mix alkaline with manganese batteries. Prevent Accidental Tape Erasure Break off the tab to protect. Record Tab Screw driver For assistance, call 1-800-211-PANA(7262) Connections Outdoor Antenna Connections Unhook the antenna from your previous TV or VCR and connect it to the back of the unit as shown in the diagram. If your antenna system has separate UHF and VHF lead-ins, you need a UHF/VHF Band Mixer (not supplied.) WARNING: When using “Nut type" RF coaxial cables, tighten with fingers only. Overtightening may damage terminals. from Antenna (Flat) Twin Lead 300 Ohm Cable Back of unit DSS/Cable box Connections ■ Without a Cable Box You can; • record or view unscrambled channels. You cannot; • record or view scrambled channels. • view a channel other than the one selected for any type of recording. I With a Cable Box You can; • record or view any channel including scrambled channels. NOTE: Channel selection must be made at the cable box. You cannot; • view a channel other than the one selected for any type of recording. • do a Timer recording of a channel unless you select it at the cable box. Note to CABLE System Installer This reminder is provided to call the CABLE (Cable TV) System Installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. I With a DSS Receiver You can; • record or view any channel including scrambled channels. NOTE: Channel selection must be made at the DSS Receiver. You cannot; • view a channel other than the one selected for any type of recording. • do a Timer recording of a channel unless you select it at the DSS box. NOTE: The DSS receiver must be turned off to view programs from a cable box or antenna. See the DSS manual tor details, 7 Getting Started One Time Setup When the unit is turned on the first time, setup mode is entered automatically. Press POWER on the remote or unit 1 o 2 SELECT LANGUAGE PUSH CH à. : Eng I i sh OPRIMIR CH ▼ :EspañoÍ APP, VOL + : Français Select the language. — for English —for Spanish (Español) —for French (Français) • If wrong language is set, complete “Reset all unit Memory Functions" steps page 35. • If you use a cable box, it must be left on. 3 CHANNEL/CLOCK AUTO SET CONNECT ANTENNA CABLE AND IF YOU USE A CABLE BOX, TUNE IT TO YOUR LOCAL PBS CH THEN. . , PLEASE PUSH CH UP KEY Start Channel Auto Set and Clock Auto Set. Press CH ▲. Process of Setup lo Language channel Clock POWER I- /2 CHANNEL /3“P 2 CHANNEL DOWN 2 VOLUME UP CH AUTO SET PROCEEDING AUTO CLOCK SET PROCEED ING V V Case 1 (Setup completed) 6/ 7/2000 WED 12:00PM DST: ON SETTING : CH 10 AUTO CLOCK SET COMPLETED END : PUSH CH UP KEY Press CH ▲ to exit. • It your area observes daylight saving time, but you would like to turn the DST feature off, complete the ‘To Set or Reset the Clock” step on page 34 and set DST: OFF. If your area observes daylight saving time and DST is set to ON, but the time is incorrect; complete the Time Zone Adjust steps on the next page. Case 2 (Setup incomplete) AUTO CLOCK SET IS INCOMPLETE PUSH ACT I ON TO SET CLOCK See Case 2 next page. IMPORTANT NOTE FOR AUTO CLOCK SET • Auto clock set is performed the first time when the unit is turned off each day. If used, a cable box must be left on and tuned to the PBS channel at the time the unit power is turned off if you want auto clock set to be done. • If using a DSS receiver, it must be turned off for auto clock set. • If a Cable Box or DSS receiver is connected to the unit via AudioA/ideo Jacks, an RF coaxial cable must also be connected for auto clock set and channel auto set features. • If for any reason the time is changed manually, automatic time correction will not occur. 8 For assistance, call 1 -800-211-PANA(7262) (CaseTj Set TIME ZONE ADJUST Display MAIN MENU. Press ACTION. 2 MAIN MENU SELECT :A ▼ ■* ...

Herunterladen

Geben Sie zwei Ziffern: