Stimmen - 3, Durchschnittliche Bewertung: 3.3
(
)
)
|
Anleitung Zusammenfassung
Do not use this drying rack when there are other clothes in the dryer. Stainless Steel Drum (on some models) The stainless steel used to make the normal use, the drum will not rust or dryer drum provides the highest reliability corrode. These surface blemishes will available in a GE dryer. If the dryer drum not affect the function or durability of should be scratched or dented during the drum. 9 Consumer SupportTroubleshooting Instructions About reversing the door. Safety InstructionsConsumer Support Troubleshooting Tips 1 Operating Instructions Reversing the Door ools needed: Standard #2 Tape-tipped Phillips screwdriver putty knife Open the door and remove the filler plugs opposite the hinges. With the door completely open, remove the bottom screw from each hinge on the dryer face. Insert these screws about half way into the TOP holes, for each hinge, on the opposite side (where you removed the filler plugs). Apply firm pressure to get the screw started in new holes. 2 3 Loosen top screw from each hinge on the dryer face half way. With one hand holding the top of the door and the other hand holding the bottom, remove the door from the dryer by lifting it UP and OUT. Rotate the door 180°. Insert it on the opposite side of the opening by moving the door IN and DOWN until the top hinge and the bottom hinge are resting on the top screws inserted in step 1. 4 Remove the remaining screws from the side of the opening from which the door was removed. With these screws, secure each hinge at the bottom. Tighten the two top screws of each hinge. Reinsert the plastic plugs on the side from which the door was removed. 10 Loading and using the dryer. Always follow the fabric manufacturer’s care label when laundering. Sorting and Loading Hints As a general rule, if clothes are sorted properly for the washer, they are sorted properly for the dryer. Do not overload. This wastes energy and causes wrinkling. Do not dry the following items: fiberglass items, woolens, Do not add fabric softener sheets once the load has rubber-coated items, plastics, items with plastic trim and become warm. They may cause fabric softener stains. foam-filled items. Bounce® Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the manufacturer’s instructions. The Exterior: Wipe or dust any spills or washing compounds with a damp cloth. Dryer control Stainless Steel: To clean stainless steel surfaces, use a damp cloth with a mild, non-abrasive Care and Cleaning of the Dryer Consumer SupportTroubleshooting Instructions panel and finishes may be damaged by some laundry pretreatment soil and stain remover products. Apply these products away from the dryer. The fabric may then be washed and dried normally. Damage to your dryer caused by these products is not covered by your warranty. The Lint Filter: Clean the lint filter before each use. Moisten your fingers and reach into the filter opening. Run...
Dieses Handbuch ist für folgende Modelle:Bohrmaschinen und Schrauber - DX2300 (381.67 kb)
Bohrmaschinen und Schrauber - DHDSR45 (381.67 kb)
Bohrmaschinen und Schrauber - DBSR453 (381.67 kb)
Bohrmaschinen und Schrauber - DBXR463 (381.67 kb)