Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Black & Decker Dateigröße: 2.96 mb Dateiname: Unterrichtssprache:

NOTE: Some building materials contain steel reinforcements. MILWAUKEE Dymobits can cut through embedded steel, but are not recommended for coring solid steel plates. Horizontal Coring (walls) For specific instructions on using anchors, see "Using an Expansion- Type Anchor". WARNING! To reduce the risk of injury always use an expansion-type anchor during horizontal coring. Vacuum systems can slip when used on a vertical surface. Vertical Coring (floors) Two methods will work to secure the rig for vertical coring: either an expansion-type anchor OR a vacuum pump and vacuum pad system. Securing the rig with an anchor gives better bit performance because the attachment is more rigid. For specific instructions on assembling the vacuum system, see "Assembling and Using a Vacuum System". Optional Telescoping Assembly The telescoping assembly can be used to supplement either securing method. NOTE: Vac-U-Rig® Cat. No. 4136 includes a vacuum pump and vacuum pad. However, for some applications, you may choose to use an expansion- type anchor to secure the tool. Anchors and Telescoping Assembly are not supplied with any of the above rigs. Telescoping Assembly can be purchased separately (see “Accessories”). Anchors unavailable through MILWAUKEE. OPERATION Securing the Equipment to the Work Surface - Using an Expansion-Type Anchor (Fig. 10) For Catalog No. 4125 & 4130 only. Leveling Screws Rod or Bolt Nut & Washer or Vacuum Pad Nut Fig. 10 Use a 5/8" expansion-type anchor (not supplied) that will accept a 5/8" threaded rod or bolt to secure the base to the work surface. 1. Level the stand with the four (4) leveling screws using the bubble level as a guide. When the stand is level, tighten the four (4) nuts on the leveling screws. 2. Using an expansion-type anchor, insert a threaded rod or bolt through the slot located on the base of the Dymorig and tighten the bolt or washer and nut firmly in the anchor following the anchor manufacturer's instructions. Assembling and Using a Vacuum System (Fig. 11 & 12) For Catalog No. 4115, 4125 & 4130 only. Vacuum Gauge Small Hole for Attaching Pump to Dymorig Stand Fig. 11 Coupler Vacuum Release Valve Filter Jar Vacuum Hose Vacuum Pad Vacuum Pad Nut Fig. 12 Leveling Screws Vacuum Line Coupler Vacuum Pad Stud page 8 One vacuum pad is supplied with the Vac-U-Rig® and they can be purchased separately for other Dymorigs. The vacuum pad is most effective when it is secured to a relatively smooth surface such as poured concrete. If the surface is too porous or rough, the pad may not hold securely. Before using a vacuum pad, always check the gasket on the underside of the pad to make sure it isn't worn, cracked or torn. If it is, immediately replace the gasket, otherwise the vacuum pad may not hold the rig securely. To replace the gasket, see "Replacing Vacuum Pad Gaskets" in the "Maintenance" section. See "Accessories" for gasket part number. 1. To use the vacuum pad, tilt the base of the rig and slide the vacuum pad under it so...

Herunterladen

Geben Sie zwei Ziffern: