Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Important Keep your carton packaging until your wine cooler has been thoroughly inspected and found to be in good condition. If there is damage, the packaging will be needed as proof of damage in transit. How to Install Your Refrigerated Wine Cooler Select Location: The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out of direct sunlight and away from heat sources. Best performance will be maintained when installed within the following parameters: Ideal Ambient Temperature Range Built-in 18° – 27°C Free-Standing 18° – 32°C Cabinet Clearance: Ventilation is required from the bottom front section of the unit. Keep this area open and clear of any obstructions. Electrical Connection WARNING - THIS APPLIANCE MUST BE EARTHED. All external wiring must comply with the IEE Regulations for the Electrical Equipment of Buildings. Connections to the electrical supply can be made with either a plug and socket or be permanently wired via a double-pole switch. The appliance is supplied with a 250V PVC(85°C) core cable (0.5mm.x2.5 metres long). Any replacement cable fitted must follow this specification. The unit may be supplied with either a moulded or rewirable plug. Should the plug not fit the socket at the installation site it should be removed and replaced with the correct type of plug. Moulded Plugs: If a moulded plug is fitted which is not suitable, it must be removed and disposed of. To avoid the risk of electrocution, a plug must not be left where a child may plug it into a supply socket. It must not be used for any other appliance. A three pin plug to BS 1363 with a capacity of not less than 13A must be used and fitted with a 13A fuse ‘ASTA’ approved to BS 1363. If you replace the fuse, the cover must be refitted. If the cover is lost, the plug must not be used until a replacement has been obtained from your supplier. The colour of the fuse cover is that of the insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement cover. If your appliance has a moulded plug, you do NOT have to do the following assembly as shown in Figure 1. Appliances with moulded plugs are ready to use as is. Important: The wires should be connected to the ter minals of the plug as follows: Earth to the terminal marked E or coloured Green or Green/Yellow. Neutral to the terminal marked N or coloured Black or Brown Live to the terminal marked L, or coloured Red or Brown When wiring the plug, ensure that all strands of wire are retained in each terminal. The flexible mains cable, plug and socket must not be exposed to flue products or be allowed to come in contact with a hot surface. The cable must not be trapped or pulled taut when the appliance is pushed into position. Green/Yellow (earth) Blue (neutral) Fuse (13A) Brown (live) Plug in the mains cable and switch on the electricity supply. Figure 1 Under Counter Wine Cooler Specifications Dimensions W x H x D (mm) 606 x 864 x 616 Weight 59 kg Capacity 50 Wine Bottles Temperature 5-17°C Power Supply 230V supplied with a 13 amp plug How to Operate Your Refrigerated Wine Cooler Set the Control: The total available temperature range of the unit is from 5°C to 17°C. The middle range on the control is approximately 13°C. The temperature can be lowered or Control Knob raised by turning the control clockwise or counterclockwise, respectively. As with any refrigeration product, Figure 2 there is a slight temperature variance at different locations within the cabinet. For example, the coolest bottles will be in the middle shelves. The bottles on the top two shelves will be 1°C to 2°C warmer. This is the warmest location. The bottles in the front of the shelves will be 1°C to 2°C warmer than the rear of the shelves. Position your wine inventory accordingly. To start your appliance, use a screwdriver to turn the control clockwise to the middle thermostat setting (see figure 2). Once the bottles are loaded, allow at least 48 hours for the unit to stabilize before making any adjustments to the initial setting. We recommend you place a small thermometer inside the wine cooler that is visible when looking through the glass door. This will help you establish the cabinet interior temperature you wish to store your wine collection at. Insert Wine Bottles: The top two fixed-in-place racks each hold six bottles, two deep with the necks alternating front (rear bottles) to back (front bottles), See figure 3. The middle four slide-out racks each hold eight bottles, two deep with necks alternating front (rear bottles) to back (front bottles). The bottom rack holds six bottles that are loaded with necks facing the rear. Tall bottles should not be loaded on the bottom rack because they may prevent the door from closing. Rear Bottles (Necks Facing Front) Front Bottles (Necks Facing Rear) Figure 3 Appliance Features Adjustable Temperature Control: The temperature control is fully adjustable from 5°C to 17°...
Dieses Handbuch ist für folgende Modelle:Dispenser - Refrigerated Wine Cooler (73.38 kb)