Stimmen - 2, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
Refer to the installation manual and Figure 3 for the counter mounting template. NOTE: Adjust the automatic agitation timer located in the dispenser’s electrical control box to 5 seconds on, 20 minutes off. Access to the timer is provided by removing the merchandiser/upper front panel. 1. Remove the (2) screws from each side of the dispenser cabinet. and the plastic hopper covers (2) that were shipped with the unit. 2. Place the “K” style lid on the unit and use the (4) screws that were removed to fasten the lid in place. 3. Install the ice baffle on the lid assembly as shown in Figure 2. IMPORTANT: The baffle prevents ice from overfilling the manual fill area during agitation/ dispensing with a full storage bin and forcing the manual fill cover off. Release Date: October 29, 2010 Revision: B © 2007-2010, IMI Cornelius Inc. - 1 -Publication Number: 620204725INS ED/DF300 22” CCM322/522 Nordic Style Lid Kit Installation Instructions 4. Seal the icemaker to the top of the dispenser after determining the correct location for the ice maker (see Figure 1). A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so that the ice maker will set on the RTV. B. Set the ice maker onto the lid and position it as required. C. Wipe away the excess RTV. 5. 5. Drill 0.147” diameter holes into the ice maker cabinet and the dispenser lid using the icemaker mounting brackets as templates. USE CAUTION SO AS NOT TO DRILL INTO ANY ICEMAKER COMPONENTS (CONDENSER, TUBING, ETC.). Secure the brackets using the #10 sheet metal screws provided. 6. Install the wire form bracket, supplied with the bin stat kit (item 4), through the 5/8” diameter hole in the bottom of the ice maker. Wrap the eye of the wireform over the stud near the hole to the end of the wireform bracket and wrap the tube around the end of the bracket several times, insuring the tube is secure. NOTE: The bin stat must not interfere with the agitator rotation or in the path of ice falling from the ice- maker. If it interferes with the agitator or in the path of ice, bend the bracket out of the way. IMPORTANT: Do not use the spacers provided for mounting the bin thermostat capillary tube to the Icemaker base. 7. 7. Locate the cleaning caution label (item 5) on the manual ice fill cover (item 4) as shown in Figure 1. Place the manual fill cover in position over the flange on the lid assembly and the front access hopper opening. 8. The unit is now ready for operation. Figure 1. ED/DF300 Kit Publication Number: 620204725INS - 2 - © 2007-2010, IMI Cornelius Inc. ED/DF300 22” CCM322/522 Nordic Style Lid Kit Installation Instructions Figure 2. ED/DF300 Kit Baffle Installation Figure 3. ED/DF300 Mounting Template © 2007-2010, IMI Cornelius Inc. - 3 -Publication Number: 620204725INS ED/DF300 22” CCM322/522 Nordic Style Lid Kit Installation Instructions FRONT PANEL OF ICE MAKER REMOVED FOR CLARITY SEE DETAIL X IN FIGURE 3 Figure 4. Bin Stat DETAIL X SCALE ...
Dieses Handbuch ist für folgende Modelle:Dispenser - ED/DF300 (1.14 mb)