Stimmen - 0, Durchschnittliche Bewertung: 0 ( )

Hersteller: Philips Dateigröße: 324.73 kb Dateiname: Unterrichtssprache:

. • Table of contents Charge the battery The rechargeable battery Philips LFH9154 can be charged in the Voice Tracer. When the Voice Tracer is connected to a computer, the rechargeable battery is automatically charged. A complete recharge cycle takes about 2.5 hours. D Notes • Fully charge the battery before first use. • The computer must be ON when charging the batteries. • If the USB port of the computer does not supply enough power capacity, disable the charge function (for details see chapter 8, Customize settings on page 14) and use an external battery charger. Get started Power on/off 1 To power on, press the f button until the display shows a short animation [ ]. 2 To power off, press the f button while the recorder is stopped until the display shows BYE. Keypad lock (HOLD function) 1 Slide the HOLD switch up into the Hold position to lock the keypad of the recorder. • The display briefly shows ‘On Hold’ and turns off. Using the Voice Tracer with a computer As a USB mass storage device, the Voice Tracer offers a convenient way to save, back up and move files. The Voice Tracer connects to a computer using a USB connection and does not require special software to be installed. The Voice Tracer is automatically displayed as a removable drive. D Notes • Do not disconnect the Voice Tracer from the computer while files are transferred from or to the recorder. The record / play indicator 1 flashes orange, when data is being transferred. HOLD 2Slide the HOLD switch down to the Off position to disengage the keypad lock. 1 • Do not format the drive of the Voice Tracer on a computer. Formatting on the Voice Tracer uses the correct file system and automatically creates the required folders. Get started • Table of contents 5 Record Please note the instructions in this section when you make the first recording with your Voice Tracer! Record with the built-in microphone 1 Press the INDEX/a button while the recorder is stopped to select the desired folder. 2 Press the g button to start recording. • The record / play indicator lights red. • Point the built-in microphone toward the sound source. 3 To pause recording, press the g button. • The record / play indicator will blink, and PAUSE will flash on the display. 4 Press the g button again to resume recording. 5 To stop recording, press the j/DEL button. • Table of contents D Notes • Set the desired voice activation function and recording mode before starting recording (see chapter 8, Customize settings on page 14 for more information). • Make a test recording to make sure that the Voice Tracer settings are correct. • Press and hold f during recording to display the remaining recording time. •Press b during recording to create a new file. • The maximum number of files in each folder is 99, for a total capacity of 396 files (99 files x 4 folders). • If the recording time exceeds the available capacity or the number of files reaches 396, recording stops and FULL will be displayed. Delete a few recordings or move them to a computer. • Do not remove the battery when recording is in progress. This can cause the unit to malfunction. • If you are to start a long recording session, replace the batteries before you begin. Record Record with an external microphone To record with an external microphone, connect the microphone to the microphone jack and follow the same procedure as for the built-in microphone. The built-in microphone is switched off when an external microphone is connected. D Notes • The index icon index marks. indicates that the recording contains 1 Add index marks Index marks can be used to mark certain points in a recording as points of reference (for example, to mark the start of a new subject of discussion). 1 • Up to 32 index marks can be set per file. 1 Press the INDEX/a ...

Herunterladen

Geben Sie zwei Ziffern: