Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Be sure to remove the sticker before using the clock. • Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the illustration. •This product has a sweep second hand. • (TQ-551) Pressing SNOOZE/LIGHT illuminates the face of the clock for about three seconds for easy reading of the time in the dark. • (TQ-551) This product has a luminous resin face that accumulates light for easier reading. • (TQ-451) This product uses luminous paint for face markings and on its hands. Next alarm dial Alarm ON/OFF switch Minutes Hand Alarm Hand Hour Hand Seconds Hand LIGHT LUMINOUS RESIN LUMINOUS PAINT TQ-451 X X O TQ-551 O O X ABOUT THE LUMINOUS PAINT When the face of the timepiece is exposed to fluorescent light, the luminous paint stores the light, which it then emits to glow in the dark for easy reading. •The luminous paint used by this product does not use any radioactive material. It is personally and ecologically safe. •The amount of time before the glow emitted from the luminous paint starts to weaken is about five hours. This time, however, depends on the brightness and angle of the light to which it was originally exposed. •Since ultraviolet light charges the luminous paint, you should use this timepiece in a room illuminated by fluorescent light. TO SET THE TIME Rotate the Time setting dial to change the time setting. • Be sure to always press RESET with a thin object after loading batteries. USING THE ALARM This clock has two alarms. The 1st Alarm is the alarm that sounds when the current time reaches the alarm time you set. The Next Alarm sounds after passage of the time setting of the NEXT ALARM dial, starting from the point that the 1st alarm begins to sound. The Next Alarm also has a snooze feature. The alarm on/off setting affects both the 1st Alarm and the Next Alarm. You cannot turn the 1st Alarm and Next Alarm on and off individually. The Next Alarm sound is relatively louder than the 1st Alarm sound. To set the alarm 1. Rotate the Alarm setting dial in the direction indicated by the arrow marked on clock to move the alarm hand to the 1st Alarm time setting you want. 2. Rotate the NEXT ALARM dial from 1st Alarm to the Next Alarm setting you want to use. •You can set the Next Alarm to any time from 5 to 60 minutes, in 5-minute steps. 3. Set the Alarm ON/OFF switch to ON. • If the Alarm ON/OFF switch is already set to ON, always be sure to change its setting to OFF and then back to ON again after making alarm time setting changes. • Note that this clock does not distinguish between AM and PM times. If you set an alarm to wake up to in the morning, the alarm will sound again at the same time in the evening if you leave the Alarm ON/OFF switch in the ON position. To use the alarm The 1st Alarm starts to sound when the current time reaches the time indicated by the alarm hand. Th...
Dieses Handbuch ist für folgende Modelle:Heimkino-Systeme - TQ-451/551 (51.45 kb)