Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Repeat these steps to program the remaining tracks in your selection. Alternatively, press ‘PROG’ once and enter your track selection using the 0–9 keypad. The display shows the track numbers programmed, the total length of the programmed sequence and the number of tracks programmed (shown by a number below the word ‘STEP’). Each time you enter a track, the number below ‘STEP’ increments by one and flashes until you press ‘PROG’ to confirm. If you fail to press ‘PROG’ within about five seconds, the display stops flashing and you will have to reselect the track. Press ‘’ to play the program. Press ‘’ again to replay the entire sequence from the start. Press and hold ‘CLEAR’ to erase the programmed sequence. Press ‘PROG’ again to exit the program facility: the display flashes ‘CONTINUE’ and shows ‘0’. RPT To repeat the entire CD or a pre-programmed selection of tracks press ‘RPT’ once: ‘REPEAT’ lights on the display. To repeat a particular track, select that track and then press ‘RPT’ twice so that ‘REPEAT 1’ is shown on the display. If you now select a different track, that track is repeated instead. To cancel the repeat function press ‘RPT’ a third time. SKIP AND SEARCH TRACK Skip track backwards and forwards; Search backwards and forwards. OPEN Opens and closes the CD tray PLAYBACK CONTROL Pause, Play and Stop MUTE Stops sound to the speaker outputs of certain Arcam amplifiers. P MODE Press once to shuffle play CD tracks (i.e. play them in a random order). Press again to cancel shuffle play. VOLUME +/– Adjusts the volume on Arcam remote-controllable amplifiers. Note that the volume ‘+/–’ controls and ‘MUTE’ button have no effect on the audio output level of the CD players. TITLE Press ‘TITLE’ once to display the remaining time of the currently playing track. Press again to display the time remaining of the disc. Press a third time to turn the text display on. Press ‘TITLE’ again and the display reverts to its original setting, showing the time elapsed for the current track. For CDs with text, pressing ‘TITLE’ once while the disc is loaded but not playing displays the artist’s name. Pressing ‘TITLE’ a second time displays the total number of tracks and the total playing time. NOTE Remember to install the two AAA batteries supplied before trying to use your remote control. Do not place anything in front of the FMJ badge on the top left of the CD player (where the IR receiver is located), or the remote control may not work. Note that greyed-out buttons on the remote control are DVD-specific and are not used with the CD player. Technical specifications NOTE: All specification values are typical unless otherwise stated. Digital to Analogue conversion High performance 192kHz 24-bit sample rate converter and multiple 24-bit digital to analogue conversion Laser pick-up 3 beam Laser wavelength 780nm Numerical aperture 0.45 Dynamic range (unweighted) >93dB * Signal to noise ratio 113dB Harmonic distortion (0dB, 1kHz) <0.003% * Frequency response (±0.2dB) 10Hz–20kHz Output level (0dB) 2.2Vrms Output impedance 50. Minimum recommended load 5k. * Using 16-bit, triangular p.d.f. dithered data Physical Dimensions W430 x D290 x H85mm Weight 6.5kg nett/8.4kg packed Power consumption 32VA maximum Digital output connection 75. co-axialoptical TOSLINK Supplied accessories Mains lead CR-314 remote control2 x AAA batteries E&OE CONTINUAL IMPROVEMENT POLICY Arcam has a policy of continual improvement for its products. This means that designs and specifications are subject to change without notice. RADIO INTERFERENCE The FMJ CD player is a digital audio device which has been designed to very high standards of electromagnetic compatibility. CD players generate, and can radiate RF (radio frequency) energy. In some cases this can cause interference with FM and AM radio reception. If this is the case, keep the CD player and its connecting cables as far from the tuner and its aerials as possible. Connecting the CD player and the tuner to different mains sockets can also help to reduce interference. EC COUNTRIES -– These products have been designed to comply with directive 89/336/EEC. USA – These products comply with FCC requirements. LASER RADIATION If an Arcam CD player is operated whilst the outer casing is removed, invisible laser radiation could cause eye damage. Guarantee For further details contact Arcam at: Arcam Customer Support Department, Pembroke Avenue, Waterbeach, CAMBRIDGE, CB5 9QR, England Telephone: +44 (0)1223 203203 Fax: +44 (0)1223 863384Email: support@arcam.co.uk PROBLEMS? Always contact your dealer in the first instance. If your dealer is unable to answer any query regarding this or any other Arcam product please contact Arcam Customer Support on +44 (0) 1223 203203 or write to us at the above address and we will do our best to help you. ON LINE REGISTRATION You can register your Arcam product on line at: WORLDWIDE GUARANTEE This entitles you to have the unit repaired free of charge, during the firs...