Pre-set brightness and contrast levels optimized for day or night operation. Adjustable tilt control to see upward image when use tilt camera. Adjustable tilt control to see downward image when use tilt camera. Variable control of contrast. Should be adjusted if the "DAY/ NIGHT" switch does not achieve the most desirable picture. Variable control of brightness. Should be adjusted If the "DAY/ NIGHT" switch does not achieve the most desirable picture. Variable control of internal speaker vol

Hardware included • IR LED Low Light Enhancement Recommended grommet Hole & Mtg. thickness Contents: Camera Bracket Hardware Kit Installation and Pin Out: Waterproof Camera Connector Standard Cable Connector / ,, . '=o=d^] rflwi3=[IH-JD I / Grommet To Seal Through Vehicle Exterior Arrow Locking Location Audio«. k 12V DC Ground/Shield Cable Connector End View LED Assisted Illumination Microphone f Selector Installation Screw For Use Hex Socket Hoad M4X10L Stainless screws Spring

This will avoid possible damage to cable during operation.(See Fig.3) 3. The red wire is connected to an ignition power source, the black wire is connected to chassis ground, and the blue wire is connected to the rear gear position, the brown and green wires are connected to the direction signals.(See Fig.3) 4 Voyager VOM-783 OPERATIONS MANUAL FUNCTIONS AND OPERATION Front of Monitor : See FIGURE 4 1. Power switch : STAND- BY Monitor operates when vehicle transmission is switched into "RE

This manual contains instructions to ease installation of the camera and monitor. The VOYAGER Observation System is a supplement to standard rearview mirror systems, and will provide additional rearview vision when installed and maintained properly. The VOYAGER Observation System is not intended in any way to be a substitute for careful, cautious, defensive driving or for the consistent adherence to all applicable traffic laws and motor safety regulations. This product is not intended to be a

Be sure to drill a 19mm (3/4") diameter hole only. 2. Feed as much cable as possible into vehicle and clamp securely. This reduces the possibility of being hooked during production. 3. Keep all cables away from HOT, ROTATING and ELECTRICALLY NOISY components. 4. To increase protection of cable, place all excess wire and extension cable in convoluted tubing. 5. Do not twist camera cable and do not cut camera pigtail or cable. WIRING MONITOR 1. See wiring diagram for connections to ignition