Stimmen - 1, Durchschnittliche Bewertung: 3 ( )

Hersteller: Audiovox Dateigröße: 750.64 kb Dateiname: Unterrichtssprache:

Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 11. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna. FIGURE 11 Caution: Do not overtighten screws. Use extra support for the console until secured to the vehicle. Failure to do so may cause damage to console or installed components. 13. Raise console into approximate position and connect wiring to O.E. components. FIGURE 12 14. Carefully position console against headliner. Loosely install using (2) two 6-32 X 3/4" screws (item 3 pg 2) through the smaller holes in bracket on console into threaded clips on mounting bracket. 15. Secure the front of console to the inner roof of vehicle using original screw in original location. See Figure 12. 16. Using an awl or similar tool, align the rear mounting holes with holes in bracket. Apply upward pressure to console and secure using (2) two #8 x 3/4" screws (item 2 pg 2). See Fig. 12. 17. Tighten (2) two 6-32 X 3/4" screws previously installed in step 14. 7 18. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing. 19. Raise video system into approximate position and connect all wiring to components. Route video cable through hole in mounting bracket. Connect wiring and cabling to video system per instructions included with video system. 20. Check function of all components and lights. See operating instructions for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area. 21. Insert video system into opening in console. Note: Make sure that wires do not get pinched between bosses on video system and console. Align holes in housing with clips in mounting bracket. Loosely install (4) four 6-32 X 3/4" screws (item 3 pg 2) and (4) four 3.5mm washers (item 4 pg 2). Caution: Do not overtighten screws. See Figure 13. 22. Raise video screen into locked position. FIGURE 13 23. Through the open compartment door on O.E.M. console, use an awl or similar tool to align holes in console with holes in bracket. Secure using (2) two #8 x 3/4" screws (item 2 pg 2). See Fig. 14. Close compartment door. 24. If console was equipped with a Homelinktm Transmitter, refer to the vehicle owner’s manual for reprogramming instructions. FIGURE 14 8 ...

Herunterladen

Geben Sie zwei Ziffern: