Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Carcomm Dateigröße: 951.36 kb Dateiname: Unterrichtssprache:

The blue wire of the power cable is used for the ignition sense feature.The blue wire is connected via a 2A fuse to a 12 volt supply that is controlled by the ignition key. Do not connect it directly to the high voltage sections of the ignition circuit. When the PDA is taken from the cradle, the carkit will go in standby mode after a few minutes. Radio Muting The Hands Free PDA Carkit offers a feature which can mute the car radio automatically during a phone call, when playing audio or when a voice command is given by for example navigation software which is installed on your PDA. To avoid interference, the yellow wire is switched to the GND (max 50mA), which mutes the radio. When installed with the power cable it is possible to take over the front left or front right speaker. The yellow wire in the power cable needs to be plugged in the correct position of the vehicle’s radio ISO connector which is installed in the vehicle. Please check your vehicle’s radio manual for the correct position. To play the audio over the right/left front car speaker, please check table 1 how to connect the wiring. The carkit is not suitable to use to play music on, the frequency range is optimized for voice frequencies and the signal is coming from the carkit is a mono signal. Figure 1. Table 1. Connecting a Carcomm Euro-Navigator GPS Receiver. (optional) The phones supported by this cradle only support Bluetooth GPS Receivers. When installing a Bluetooth GPS Receiver please follow the instructions supplied with the product, phone and software to set it up. Connecting the Carcomm CIGM-918 Quad-Band Inside-Glass Antenna. (Optional) Connect the FME Female plug from the CIGM-918 to the FME Female connector of the Smartphone cradle. The Antenna should be mounted onto the vehicle’s windscreen with the VHB tape inside the vehicle. Remarks In vehicle’s with UV / heat protected windows the GPS reception can be influenced and decreased. Communication settings of the PDA should be set to Serial on COM1. 2 ...

Herunterladen

Geben Sie zwei Ziffern: