Stimmen - 5, Durchschnittliche Bewertung: 3.6 ( )

Hersteller: Athena Technologies Dateigröße: 498.92 kb Dateiname: Unterrichtssprache:

Notes 2) Once you have determined mark the cut-out on the wall mark the cut-out size, simply trace an outline pencil. 3) Using the appropriate wall cutting tool, on the appropriate cut-out dimension. 4) Install speaker cable(s) from the receiver or and leave enough slack in the wire so it can hang Using the appropriate wire is essential, as your local municipality that must be maintained. NOTE: To connect the AS-IC6st you will need to run both the cables to one single hole as this speaker has stereo input 5) Connect the speaker wire from the positive (RED +) terminal on the (RED+) terminal on the speaker. Connect the negative (BLACK-) terminal on the receiver to the negative (BLACK-) terminal on the speaker. To connect the wire to the speaker, completely push the appropriate terminal in, and insert the wire through the appears on the terminal. Release the terminal and the internal springs will hold in place. Repeat for the other terminal. NOTE: If you inadvertently reverse one of the connections (i.e, red to black), notice a severe lack of bass from your system. This is called wiring the system Phase”. If this occurs, check the wiring and re-connect as necessary. NOTE: To connect the AS-IC6st you must repeat the connection procedure for both left and right channels on one AS-IC6st speaker. This speaker has dual input terminals providing sound for both the left and right channels of your amplifier or receiver. In Ceiling Models: (AS-IC6, AS-IC8, AS-IC6st) 6) Insert the entire speaker into the hole, and using a Philips screwdriver, tighten the screws attached to the dog clamps until firm. DO NOT OVERTIGHTEN In Wall Models: (AS-IW6) 7) NOTE: Before installing the AS-IW6, set the two position switch on the rear of the speaker to either the 0 dB or the +3db position. The zero position maintains a flat, even frequency response, while the +3db position will increase the sound output to the tweeter. The +3dB position is to be used in rooms with excessive sound absorption material such as thick carpet, drapes, couches, etc. 8) The AS-IW6 speaker installs in two stages. First remove the speaker from the bezel, by removing the 6 screws found on the front of the speaker. Once the screws are removed, separate the bezel from the baffle. 9) Insert the speaker bezel into the hole, and using a Philips screwdriver, tighten the screws attached to the dog clamps until firm. DO NOT OVERTIGHTEN 10) Once the bezel is installed, install the speaker into the mounting bezel and using a Philips screwdriver, tighten the screws until firm. DO NOT OVERTIGHTEN PAINTING THE BEZEL AND GRILLE If you wish, you can paint the speaker bezel and grille to match the decor and design of your home. 1) For the in wall model, simply separate the bezel from the speaker baffle and paint the bezel, before you install the speaker portion. The grille is easily separated and can be painted on its own. 2) For the in ceiling models, use the wall template as a paint mask. Carefully cut the marked l...

Herunterladen

Geben Sie zwei Ziffern: