Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Athena Technologies Dateigröße: 498.92 kb Dateiname: athena-Audition-Architectural-Series-Owners-Manual.pdf Unterrichtssprache:

Over-driven amplifier distortion is called “Clipping”, easily identified by its fuzzy, distorted sound, and can damage any speaker. The volume control of most amplifiers and receivers is a logarithmic type, which means that full power may be reached with the volume control set at as little as the halfway point. Operating the loudness, treble, or bass controls increases power output well beyond rated levels. The warranty on your speakers is therefore void if the voice coils are burned or damaged as a result of overpowering or clipping. LIMITED WARRANTY POLICY WARRANTY FOR UNITED STATES AND CANADA (see back cover) Warranty Outside of The United States and Canada: Product warranties may be legislated differently from one country to another. Ask your local dealer for details of the LIMITED WARRANTY applicable in your country. NOTE: Please retain the carton and packing material for your athena TECHNOLOGIES ® products to protect them in the event of a move or if they need to be shipped to a service center. Product received damaged by a service center that has been shipped by the end user in other than the original packaging will be repaired, refurbished and properly packaged for return shipment at the end user's expense. INSTALLATION INSTRUCTIONS NOTE: If you are unable to install the speakers yourself , please contact an authorized installation contractor, or your authorized athena TECHNOLOGIES ® retailer. Caution: Turn off all power in your audio/video system before proceeding with your installation. Not doing so could result in potential damage to the system. To install the speakers follow these easy steps: 1) Decide the placement for your speakers. Advanced planning in regards to the placement of your speakers is critical. It is imperative that the wall or ceiling cavity be free from debris, moisture, wall insulation, and any material that is easily combustible. The mounting location must also be void of wall studs or bracing, in the location for the cutout. Adequate depth for the speaker to fit flush to the wall or ceiling surface is important. If you are unsure about the contents of the wall in which you wish to mount the speakers, simply drill a small hole and using a metal clothing hanger, insert the end of the hanger into the wall and twist it to feel for any debris or wall studs. Notes 2) Once you have determined mark the cut-out on the wall mark the cut-out size, simply trace an outline pencil. 3) Using the appropriate wall cutting tool, on the appropriate cut-out dimension. 4) Install speaker cable(s) from the receiver or and leave enough slack in the wire so it can hang Using the appropriate wire is essential, as your local municipality that must be maintained. NOTE: To connect the AS-IC6st you will need to run both the cables to one single hole as this speaker has stereo input 5) Connect the speaker wire from the positive (RED +) terminal on the (RED+) terminal on the speaker. Connect the negative (BLACK-) terminal on the receiver to the ...

Herunterladen

Geben Sie zwei Ziffern: