Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Maxon Telecom Dateigröße: 232.96 kb Dateiname: Unterrichtssprache:

All burners are available in ANSI and ISO version. Each version will have the main gas inlet connection following either NPT or ISO standards. All burners include an adjustable orifice needle valve for pilot flame fine tuning, provision for UV-scanner connection and a stainless steel combustion sleeve. Options Every burner has a set of options available, according to the table below: HTS High temperature discharge sleeve FLR Combustion air filter box, recommended in extremely dusty surroundings DI Direct ignited: in this case the adjustable orifice will be removed and the pilot connection at the burner will be plugged UVC Burner flame scanner connection prepared for UV-scanner mounting (scanner not included) CBL Connecting bracket and linkage for control motor mounting (control motor make and type to be specified) Exception: FR Flame rod, only to be used in limited number of applications, see page 1-2.3-11 The spark ignitor is standard included on the burner. .com combustion systems for industry MAXON reserves the right to alter specifications and data without prior notice. © 2008 Copyright Maxon Corporation. All rights reserved. 1-2.3-9 Low temperature burners -INDITHERM® E-m-7/08 Burner designation Burner type Burner size Burner gas connection Discharge sleeve Ignition Flame supervision INDITHERM® 300 ISO HTS DI UVC Burner size Discharge sleeve 100 HTS: High temperature 300 STD: standard version, stainless steel 550 700 Ignition 850 DI: Direct Ignition (plugged pilot port) 1100 PL: Pilot burner 1500 1800 Flame supervision UVC: prepared for UV-scanner mounting Burner gas connection FRC: prepared for flame rod mounting ISO: ISO threated NPT: NPT threaded Fuels INDITHERM® burners are designed to operate on natural gas. For propane and butane operation a standard INDITHERM® burner can not be used. Contact MAXON when the use of gases other than natural gas is inevitable. Burner discharge sleeve The burner discharge sleeve is available in different materials and geometries: • Standard version with circular stainless steel discharge sleeve and square burner mounting plate. • High temperature version with refractory block for installation in applications where high temperatures can be expected. Process air A In following cases the use of high temperature version discharge sleeve is required: • Dimension A is larger than 50mm • Insufficient low temperature process air is available to cool the discharge sleeve • No process air is available ( typical in indirect fired applications) • Process air is entered downstream of the burner, being unable to flow over the burner discharge sleeve .com combustion systems for industry MAXON reserves the right to alter specifications and data without prior notice. © 2008 Copyright Maxon Corporation. All rights reserved. 1-2.3-10 Low temperature burners -INDITHERM® E-m-7/08 Control motor mounting plate The INDITHERM® burner can be equipped with an electrical or pneumatic control motor for capacity control. A broad range of mounting plates are available to accept almost any common control motor on the market. Required torque = 1.2 Nm. Maximum capacities INDITHERM® burners will have different maximum capacities ...

Herunterladen

Geben Sie zwei Ziffern: