Stimmen - 1, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
• If a battery does not charge properly— (1) Check current at receptacle by plugging in a lamp or other appliance. (2) Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights. (3) Move charger and batteries to a surrounding air temperature of +40°F (5°C) to +105°F (40°C). (4) If the receptacle and temperature are okay, and you do not get proper charging, take or send the batteries and charger to your local Black & Decker service center. See "Tools Electric" in yellow pages. • The batteries should be recharged when they fail to produce sufficient power on jobs which were easily done previously. DO NOT CONTINUE to use the tool with its batteries in a depleted condition. Additional Safety Warnings for VP131 Charger • Use only under adult supervision, keep out of the reach of children. • Ensure outlet is secured and completely intact. Do not plug charger into a loose wall outlet. • For best results, do not combine a silver label (NiCd) and a gold label (NiMH) battery pack in the same tool as damage may result to the batteries. SAVE THESE INSTRUCTIONS Charging Procedure (VP132, VP135 Starter Kits, VP130 Two Port Charger and VP131 One Port Charger - Plugs Directly Into Wall Outlet) Starter kits: VP132 includes a VP130 two-port charger and one VP100 VersaPak battery. VP135 includes a VP130 two-port charger and two VP100 VersaPak batteries. Insert the metal end of the VersaPak battery into the charger. The indicator light will glow indicating that charging is taking place and will remain on as long as the battery is in the charger. Continuous charging is not a safety concern. NOTE: Your VersaPak batteries were sent from the factory in an uncharged condition. Before attempting to use them for the first time, they must be charged for 6 hours for conventional nickel cadmium batteries (silver labeled) and 9 hours for nickel metal hydride (gold labeled) batteries. Subsequent charging for most fix up jobs will require 3-6 hours for silver labeled and 6-9 hours for gold labeled batteries. Charging Procedure (VP160 Charger 1-hour charger with charge status indicator lights) NOTE: VersaPak Batteries Sold Separately Insert the metal end of the VersaPak battery into the charger. The indicator lights on the front of the charger will begin to flash slowly, indicating that the battery or batteries (up to four) are being charged. When the flashing light glows steadily, the battery or batteries are fully charged. Maintenance charge safely keeps batteries fully charged and ready to use. To extend battery life, leave battery in charger until ready for use. A rapid flash indicates that the battery no longer accepts a charge and should be recycled in accordance with the information in the "RBRC Seal" section. NOTE: Your VersaPak battery was sent from the factory in an uncharged condition. Before attempting to use it for the first time, it must be charged for 1 hour per battery up to 4 hours for conventional nickel cadmium...
Dieses Handbuch ist für folgende Modelle:Ladegerä - VP100 (248.5 kb)
Ladegerä - VP100C (248.5 kb)
Ladegerä - VP105C (248.5 kb)
Ladegerä - VP110 (248.5 kb)