Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
You could damage the refrigerant tubes. Leaking refrigerant may ignite or cause eye injuries. Proceed as follows: Note Approx. 4 hours before defrosting the appliance, switch on super freezing so that the food drops to a very low temperature and can therefore be stored at room temperature for a longer period. 1. Remove the frozen food and place temporarily in a cool location. 2. Switch the appliance off. 3. Pull out the mains plug or remove the fuse. 4. To accelerate the defrosting process, place a pan of hot water on a trivet in the freezer compartment. 5. Wipe up condensation with a cloth or sponge. 6. Wipe dry the freezer compartment. 7. Switch the appliance on again. 8. Put the frozen food back in the freezer compartment. Refrigerator compartment defrosts fully automatically While the refrigerating unit is running, beads of condensation or hoarfrost form at the back of the refrigerator compartment. This is quite normal. It is not necessary to wipe off the condensation or frost. The rear panel defrosts automatically. The condensation runs into the condensation channel, Fig. *. and is conveyed to the refrigerating unit where it evaporates. Note Keep the condensation channel and drainage hole clean, so that the condensation can run out. en Cleaning the appliance a=Caution ¦ Do not use abrasive, chloride or acidic cleaning agents or solvents. ¦ Do not use scouring or abrasive sponges. The metallic surfaces could corrode. ¦ Never clean the shelves or containers in the dishwasher. The parts may become deformed! Proceed as follows: 1. Before cleaning: Switch off the appliance. 2. Pull out the mains plug or switch off the fuse! 3. Take out the food and store in a cool location. Place ice pack (if available) on the food. 4. Wait until the layer of frost has thawed. 5. Clean the appliance with a soft cloth, lukewarm water and a little pH neutral washing-up liquid. The rinsing water must not run into the light or through the drainage hole into the evaporation area. 6. Wipe the door seal with clear water only and then wipe dry thoroughly. 7. After cleaning reconnect and switch the appliance back on. 8. Put the food back into the appliance. Interior fittings All variable parts of the appliance can be taken out for cleaning. Take out glass shelves Fig. 5 Lift the glass shelves, pull forwards, lower and swivel out to the side. Condensation drainage channel To clean the condensation outlet channel, the glass shelf above the vegetable drawer, Fig. 1/8, must be taken out. Regularly clean the condensation channel and drainage hole with a cotton bud or similar implement to ensure that the condensation can drain. Removing the container Fig. + Pull out the container all the way, lift at the front and remove. Vegetable container Fig. , The fascia of the vegetable container can be removed for cleaning. Press side buttons in succession and remove fascia from the vegetable container. Take out shelves in the door Fig. Lift shelves upwards and take out. en Odours If you experience unpleasant odours: 1. Switch off the appliance with the On/ Off button. Fig. 2/1 2. Take all food out of the appliance. 3. Clean interior (see chapter “Cleaning the appliance”). 4. Clean all packages. 5. Seal strong smelling food in order to avoid odours from forming. 6. Switch the appliance on again. 7. Store food in the appliance. 8. Check whether the formation of odours is still occuring after 24 hours. Light (LED) Your appliance features a maintenance- free LED light. These lights may be repaired by customer service or authorised technicians only. Tips for saving energy ¦ Install the appliance in a dry, well ventilated room! The appliance should not be installed in direct sunlight or near a heat source (e.g. radiator, cooker). If required, use an insulating plate. ¦ Allow warm food and drinks to cool down before placing in the appliance. ¦ Thaw frozen food in the refrigerator compartment and use the low temperature of the frozen food to cool refrigerated food. ¦ Regularly defrost the freezer compartment to remove the layer of frost. A layer of hoarfrost will impair refrigeration of the frozen food and increase power consumption. ¦ Open the appliance as briefly as possible. ¦ Occasionally clean the rear of the appliance to prevent an increased power consumption. ¦ If available: Fit wall spacers to obtain the indicated energy rating of the appliance (see Installation instructions). A reduced wall gap will not restrict the function of the appliance. The energy rating may then increase slightly. The gap of 75 mm must not be exceeded. ¦ The arrangement of the fittings does not affect the energy rating of the appliance. en Operating noises Quite normal noises Droning Motors are running (e.g. refrigerating units, fan). Bubbling, humming or gurgling noises Refrigerant is flowing through the tubing. Clicking Motor, switches or solenoid valves are switching on/off. Preventing noises The appliance is not level Please align the appliance with a spirit level. Use...