Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
As this gas hob is not intended for connection to an exhaust gas system, pay attention to the applicable installation conditions. The appliance may be installed in kitchen combinations made of wood or similar combustible materials without taking additional measures. The rear wall must consist of non-combustible material. A minimum distance of 300 mm from heat-sensitive items of furnishing or contact surfaces (cupboard side panel) must be observed. The hob conforms to appliance class 3 and must be installed in the worktop as shown in the installation sketch. Do not install the appliance under a suspended cupboard. For installation under a vapour extractor, a minimum clearance of 760 mm must be observed. Wall trims must be heat-resistant, and the minimum distance between the hob and the wall trim is at least 30 mm. Warning: This appliance must be installed and connected by an authorised gas installer. This appliance shall be installed in accordance with the manufacturer’s installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations, the Installation Code for gas burning appliances, AS 5601 and any other statutory regulation. Refer to the AGA Installation Code for pipe sizing details. Technical modifications reserved. Note on ventilation: this household gas cooker has a total rated thermal load of 16.5 kW. Simultaneous use of all cooking positions of the cooker generates heat and humidity in the room where it is installed. This is why attention must be paid to good kitchen ventilation. This can be guaranteed for example by installing an extractor hood with a minimum air output of 264 m3/h (= 15 m3/h per kW thermal load). To ensure ventilation, the room in which this appliance is installed must have a suitable opening, like an exterior door or a window that can be opened. When using the household gas cooker, the extractor hood must be operated in such a way, that, the more cooking positions are used, the higher the air output level must be. Connecting the appliance 105 28 1/2 " 50 max. Gas connection The gas connection must be in a location that permits access to the shut-off valve and which, if applicable, is visible after opening the door of the cabinet. By means of the included R 1/2 . . BSP Male connection (on the appliance end) with the affiliated washer, the appliance must be connected to a fixed connecting line. Electrical connection Electrical connection (AC 220-240 V) is established by means of a connecting cable with an earthing contact plug connected to an earthed socket, which must also be accessible after installation of the gas hob. When establishing connections, make sure that the connecting lead cannot come into contact with hot parts of the gas hob or other hot parts. Turn all control knobs to the OFF position before connecting the appliance to the power supply. Connection type Y: if damaged, the mains cable must be replaced by a special...
Dieses Handbuch ist für folgende Modelle:Kühlen - KG291210AU/02 (1.26 mb)