Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Temperature Display Ice scraper Ice Tray Magnetic Gasket Freezer Drawer Leveling Screws 7 Introduction Identification of Parts Note This is a basic model.The shape of refrigerator is subject to change. Temperature Display Ice scraper Ice Tray Magnetic Gasket Freezer Drawer Leveling Screws Installation Location This appliance is suitable for using at ambient temperature between +16°C and +38°C. If the ambient temperature drops below +16°C, it is possible that the freezing foods in the freezer compartment are thawed because the temperature of the freezer gets warm. We recommend that the refrigerator be installed at a dry and well ventilated place. Make sure that the appliance is not exposed to direct sunlight or placed in vicinity of a heat source such as stove, heaters, radiator. To ensure proper air circulation around the fridge- freezer, please maintain sufficient space on both the sides as well As top and maintain at least 2 inches (5 cm) from the rear wall. Note Place on a flat and firm flooring. If the floor is not even, adjust the feet by using the leveling screw at the front edge of the cabinet. If the front is slightly higher than the rear, the door can close more easily. Electrical connection This appliance should be connected to the mains AC 220~240V , 50 Hz. You must connect this appliance only to the power socket with grounding complying with the related regulations and only an approved expert should install this appliance. 8 Operation Operation Function of electronic control Starting Before switching it on, leave the appliance standing for at least 2 hours, so that the circulation of the refrigerant stabilizes and no operating problems occur. °Ch When the appliance powers on, the initial state displayed on LED is "-18°C". • Button K1 (Defrost): Press button K1 for three seconds the first time, indicator "-", "°C", "h" shut off, compressor stop running and the value displayed on LED is"OF". Press button K1 for the second time , indicator "-", "°C", "h" display normally, compressor running normally and LED displays the initial state. • Button K2 (Quick freezing): Press butoon K2 for the first time, indicator "-", "°C"shut off, indicator "h" light on and initial freezing time displayed is"3h". Press button K2 for the second time the freezing time displayed is "2h". Press button K2 for the third time the freezing time displayed is "1h". The compressor will ren from 1hour to 3 hours according to the freezing time displayed on LED. Press button K2 for the fourth time, the indicators will recover the state before quick freeze. • Button K3 (Temperature regulation): Press button K3 continuously, the provided temperature displayed will be from -14°C to -27°C circularly. 9 Suggestions on food storage Storing food Opening the door often or keeping the door opened a long time, increases the inside temperature. This causes the storage life and flavor of the foods to reduce, and increases the energy consumption. Note Do not touch deep-frozen foods with wet hands. You could get chilblains on your hands. Make sure foods that are not frozen do not touch the frozen foods. The frozen foods may melt. The packing materials suitable for refrigerating the foods are -Polyethylene bags, Plastic foil, freezing containers. The suitable wrapping materials are -Rubber band, Plastic clips, attaching tape, string. Before sealing, get rid of air from packing bags and foil.The remained air makes the storing foods dry. You can freeze foods quickly when packing is level. Do not store bottles in freezer compartment. They may break when frozen. Making Ice To make ice cubes, fill ice tray 3/4 full with water and place it on the bottom of the freezer compartment. To remove ice cubes, hold the ice tray at its ends and twist gently. Tips To remove ice cubes easily, run water on the tray before twisting. 10 Care and Maintenance Care and Maintenance Defrosting Defrosting the fridge compartment When the freezer is working, frost is formed at the rear wall of the fridge compartment and melts automatically when the compressor stops. Defrosting the freezer compartment Humidity forms frost or ice in the freezer compartment while the appliance is working or when the freezer door is opened. The thick ice and frost decrease cool air and increase the energy consumption. Defrost Ice Layer If the freezer compartment is heavily iced, defrost as follows. -Remove the frozen food, wrap in newspaper and store in a cool place. -Leave the door open, and wipe out water with a sponge. -Dry the freezer compartment thoroughly, turn on the appliance, and replace frozen foods. Tips Note Never place electrical devices in the refrigerator for defrost. Take care when using defrosting sprays for assisting defrosting. These sprays include substances containing explosive gas, or harmful for synthesis or human health. It is helpful to place a saucepan with hot water inside of the freezing room in order to assist defrost. 11 Care and Maintenance w ww Warning Cleaning Al...