|
Anleitung Zusammenfassung
3) Tighten the compression nut onto the compression fitting. Ferrule (Purchased) (Provided) Copper Tubing (Purchased) Plastic Tubing (Purchased) Household Water Line 4) Turn water on and check for any leakage. Water line must be connected to drinkable water only. Cut off 1/4 inch of the provided plastic tubing squarely to prevent leaks when reconnect. NOTE Install the water filter. The water filter in the extra space behind the vegetable Bin. NOTE 1) As shown, the fixed cap separates from the refrigerator by rotat- ing it counterclockwise. Remove the water filter from the box and put a month indicator sticker on the filter as shown on the next page. Keep the cap(A) in a safe place for recapping, when you will not use the filter. NOTE (A) 2) The water filter should be replaced every six months, so if the filter was installed in March (for example), put on the "SEP" sticker to remind you to change the filter. 31 INSTALLATION INSTRUCTIONS INSTALLATION OF THE WATER DISPENSER LINE 3) Remove the protective cap, then position and insert the filter as shown. 4) Slowly turn the water filter clockwise 90. to align COVER FILTER the indication mark on the cover, locking the filter in position. SEPARATION OF RED CAP STICKER (MONTH INDICATION) ALIGN THE INDICATION MARK WITH LOCK POSITION. NOTE • Please check that the indication line aligns with the lock position. • If you are replacing the cartridge, first remove the old one by slowly turning it to the left. Do not pull down on the cartridge. A small amount of water may drip down. • If your refrigerator does not have a water filter, we recommend installing one if your water supply has sand or particles that could clog the screen of the refrigerator’s water valve. Install it in the water line near the refrigerator. Remove any residual matter inside the water supply line after installing filter 1) Turn on the main water supply & shut-off valve of the water supply line. 2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines. 3) Additional flushing may be required in some households. 4) Open the refrigerator door and check if water leaks around ICE WATER the water filter. • A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE 32 INSTALLATION OF THE WATER DISPENSER LINE Check the amount of water supplied to the ice tray 1) To remove : Set the "Ice Type" switch to the Ice off position. Lift up (.) and pull out (.) the icemaker bucket in the freezer. To replace : When replacing the drawer, be sure to press it ICE MAKER firmly into place. If it does not go all the way back, remove it and rotate the drive mechanism 1/4 turn. Then push the drawer back again. 2) Throw away the first few batches of ice to allow the water line to clear. Be sure nothing interferes with the sweep of the feeler arm. When the bin fills to the level of the feeler arm, the icemaker will stop producing ice. It is normal for several cubes to be joined together. If ice is not used frequently, old ice cubes CHECK THE WATER LEVEL will become cloudy, taste stale and shrink. Rotate 3) Important Facts About Your Dispenser : Do not add ice from trays or bags to the storage bin. It may not crush or dispense well. Avoid overfilling glass with ice and use of Drive Mechanism narrow or extra-tall glasses. Backed-up ice can jam the chute or cause the door in the chute to freeze shut. If ice is blocking the chute, poke it through with a wooden spoon. Beverages and foods should not be quick-chilled in the ice storage bin. To keep dispensed ice from missing the glass, put the glass close to, but not touching, the dispenser opening. Some crushed ice may be dispensed even though you selected CUBES. This happens occasionally when a few cubes accidentally get directed to the crusher. After crushed ice is dispensed, some water may drip from the chute. 4) Water Supply to the Icemaker : The icemaker must be connected to a cold water line. 5) Start the Icemaker...
Dieses Handbuch ist für folgende Modelle:Kühlen - RS2611SW (2.57 mb)
Kühlen - RS2621BB (2.57 mb)
Kühlen - RS2621RS (2.57 mb)
Kühlen - RS2621SH (2.57 mb)