Stimmen - 1, Durchschnittliche Bewertung: 3
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
- If water does not come out through the line, check whether the tap is open. - Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed. WATER LINE PURIFIER OUTLET SIDE OF PURIFIER WATER 30 INSTALLING THE WATER DISPENSER LINE Attach the purifier lock stations. - Hold the purifier lock stations in the appropriate position (under the sink for example) and fix it tightly into place where to screw. INSTALLATION INSTRUCTIONS PURIFIER LOCK STATIONS TWO PURIFIER LOCK STATION TWO PURIFIER LOCK STATION BAND COMPRESSOR COVER OF REFRIGERATOR CONNECTION NUT WATER LINE WATER TUBE Secure the purifier in position. - Fix the purifier in position, as shown in the figure PURIFIER on the right. TIGHTENING Connect the water line to the refrigerator. - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. -When connected, check if there is any leakage. If any, repeat the connection. - Reattach the compressor cover of the refrigerator. Secure the water line. -Using clip ”A”, fix the water line to the wallor (the back of CLIP A refrigerator). -When the water line is secure, make sure whether the water WATER LINE line is not excessively bent, pinched or squashed. 31 INSTALLING THE WATER DISPENSER LINE Remove any residual matter inside the water supply line 1) Turn on the main water supply & shut-off valve of the water supply line. 2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines. 3) Additional flushing may be required in some households. 4) Open the refrigerator door and check if water leaks around WATER ICE the water filter. • A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. • Before reinstalling the water filter, remove the wine shelf. NOTE Check the amount of water supplied to the ice tray. 2) When you press the test button, the ice cube container is filled with water from the water supply tap. Check the amount of water (see the illustration below). If the water level is too low, CHECK THE WATER LEVEL TEST BUTTON TOO HIGH OPTIMUM LEVEL 1) Lift up () and pull out (.) the ice maker bucket in the freezer. TOO LOW ICE MAKER the ice cubes will be small. This is not a problem with the ice maker but of the water pressure in the pipe, and occurs frequently. When this problem occurs, contact the dealer service center to check the amount of water supplied. 32 TROUBLESHOOTING The refrigerator does not work at all or it does not chill sufficiently • Check that the power plug is properly connected. • Is the temperature control on the display panel set to the correct temperature? Try seting it to a lower temperature. • Is the refrigerator in direct sunlight or located near a heat source? • Is the back of the refrigerator too close to the wall? The food in the refrigerator is frozen • Is the temperature control on ...
Dieses Handbuch ist für folgende Modelle:Kühlen - 24KLDW (2.81 mb)
Kühlen - RS21FANS (2.81 mb)
Kühlen - RS24DAMS (2.81 mb)
Kühlen - RS24DANS (2.81 mb)