Stimmen - , Durchschnittliche Bewertung: ( )

Anleitung CDA, modell FWC301

Hersteller: CDA
Dateigröße: 391.1 kb
Dateiname:

Unterrichtssprache:

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin. 1 Before first use You must allow the appliance to settle for at least twenty four hours prior to switching the power on. It is recommended that you remove all internal and external packaging and clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly dry the interior. The appliance may have an odour to it at first use. This will disappear as the appliance cools. Please note: • The appliance will work continuously until it gets to the correct temperature. • If the appliance is switched off, you should allow five minutes before switching it on again to prevent the risk of unnecessary damage to the compressor. • The LED display may not show the selected temperature whilst the appliance first gets to the correct temperature. This is normal, and the display will be corrected automatically once the appliance has run for a few hours. Use • Only store wine in sealed containers • Do not overload the cabinet • Only open the door when necessary • Do not cover the shelves with aluminium foil or anything else that will prevent air from circulating around the cabinet. • To prevent damage to the door seal, ensure the door is fully open before removing the shelves. • This is a self-defrosting appliance. The compressor will not run during the thirty minute defrost cycle. • Do not pull the shelves beyond the anti-stop position (approximately one third out) when fully loaded. • This appliance is intended to be used exclusively for the storage of wine. • In the event of a power failure, leave the door closed as much as possible to maintain the internal working temperature. Should the power failure continue for a prolonged period, you should take steps to protect the contents of the wine cooler against a rise in temperature. This appliance is suitable for use in an extended temperature climate (N for FWC151, N/ST for FWC301/FWC601/ FWC621) and has a normal operating ambient temperature of 16-38C. Use of the appliance below 10C may cause performance issues that are not indicative of a fault. Normal operation will resume once the appliance is within the specified range. FWC151, FWC301 & FWC621 will not be able to reach the required temperature if the ambient temperature is lower than that required. Use and Controls FWC151 FWC301 To switch the power on/off Press and hold the power button for five seconds. To change the temperature • Press the up or down buttons until the required temperature is shown on the display. • The preset temperature is 12.C / 54. F. • To change the temperature display from Fahrenheit to Celsius, or Celsius to Fahrenheit, press and hold the light button for five seconds. • To view the set temperature, touch the up or down button at any time and the set temperature will flash in the LED display for five seconds. Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15. C, your wine can also be stored at drinking temperature. For red wine this is between 15 and 17. C, and for white wine between 12 and 13. C. To use the internal light • Press the light button to switch the light on or off. Key: 1 – Power button 2 – Light button 3 – Up button 4 – Down button fig. 1 Key: 1 – Power button 2 – Light button 3 – Up button 4 – Down button fig. 2 1 2 3 4 1 2 3 4 3 Use and Controls FWC601 Key: 1 – Light button 2 – Temperature set button 3 – Up button 4 – Down button 3 41 2 fig. 3 To switch the power on/off Press and hold the light and temperature set buttons simultaneously for five seconds. To change the temperature • Press the temperature set button once to select the upper zone. • The LED display for the upper zone will flash. • Press the up or down buttons until the required temperature is shown on the display. • Press the temperature set button again to select the lower zone. • The LED display for the lower zone will flash. • The preset temperature for the upper zone is 10.C / 50. F and for the lower zone is 16.C / 60. F. button for five seconds. • To change the temperature display from Fahrenheit to Celsius, or Celsius to Fahrenheit, press and hold the • To view the set temperature in either zone, touch the up or down button at any time and the set temperature will flash in the LED display for five seconds. Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15. C, your wine can also be stored at drinking temperature, for red wine this is between 15 and 17. C, and for white wine between 12 and 13. C. To use the internal light • Press the light button to switch the light on or off. Please note: The temperature in the lower zone must be set either the same or higher than the temperature in the upper zone. For optimal performance, the temperatures in the two zones should differ by at least 4. C Use and Controls FWC621 To switch the power on/off ...