Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Holmes Dateigröße: 926.18 kb Dateiname: d0a4246d-c2bf-4c21-b9ea-e4bba9bdc263.pdf Unterrichtssprache:

1. Ensure filter assembly is rolled straight onto the rails inside of the cabinet. 2. Push filter assembly back as far as possible 3. Ensure quick disconnect fitting on top of filter connects automatically with quick connect fitting inside of cabinet. 4. Pull on filter lightly to ensure a tight connection 1. Set the black knob in the middle of the filter control panel to the far right. 2. Try to filter again. 1. Open the door of the fryer you wish to filter. 2. Pull the return valve handle (small black knob) out as far as possible. 3. Attempt to filter again. When completed, push the black knob in as far as possible to close. – 6– Self-Help Guide (Continued) PROBLEM PROBABLE CAUSE SOLUTION (Follow Sequentially) Motor runs but will not pump oil. Oil has not penetrated the filter paper 1. Let oil sit in the filter pan for approximately 2 minutes and try again Motor not making any noise Not plugged in Motor has overheated 1. Plug filter into the receptacle inside of cabinet 2. Turn ON/OFF switch to ‘ON’. 1. Allow motor to cool for approximately 10 minutes. 2. Press the reset button near the ON/OFF switch on the filter control panel and try again. Oil not pumping through the hose Valve not switched to “Oil to Hose” 1. Set the black knob in the middle of the filter control panel to the far left. PREVENTIVE MAINTENANCE: Familiarize yourself with the proper filtering procedure prior to attempting to filter 1. To remove water, stir oil until bubbling stops; water will clog filter paper pores. 2. Verify all connections, especially quick disconnects (under tub and inside fryer or CF cabinet) are tight; not leaking oil or sucking air. 3. Use only one sheet of filter paper properly sealed under hold down ring. 4. Use a drain clean out rod if partial or full blockage in fryer drain is suspected. 5. If filter was used for fryer boil out, run oil through filter to lubricate motor/pump. 6. Clean filter and all components after each use. Do not permit oil to remain in filter drawer; it will clog the pump. 7. Verify all lights and controls operate. 8. Adhere to operating instructions in sequence given for proper filtration. 9. Prepare filter for next use by using new filter paper and Acidox Powder for each fryer. – 7– WIRING DIAGRAM KEATING OF CHICAGO, INC. Tel. 708-544-6500 • Fax 708-544-6505 If you have any questions regarding filtering Toll Free 1-800-KEATING (In U.S. and Canada) procedures or need assistance, call: 1-800-KEATING. manuals/domestic/filters/safeandeasy – 8– WARRANTY WARRANTY Keating Of Chicago, Inc. ("Keating”) warrants to the original purchaser. ("Customer"), all new Keating Fryers, Filter Systems, Griddles, Keep Krisp®, Custom Pasta Systems, Top-Side™ Cookers, Computer Timers, Fryer& Pasta Vessels, and Keating replacement parts ("products") installed after June 1, 1994 to be free to defects in material or workmanship, subject to the following terms and conditions. LENGTH OF WARRANTY All products other than Fryer & Pasta Vessels and replacement parts shall be warranted for a period of one year from the date of original equipment installation. Keating replacement parts are warranted for a period of ninetydays from the date of installation. Fryer & Pasta Vessels are warranted as described below. FRYER & PASTA VESSEL WARRANTY Fryers purchased after June 1, 1994 carry a prorated vessel warranty on defects in materials or workmanship to the Customer based on the following scale: Time from Installation Date Fryer Vessel Warranty Credit 13-60 months 100% 61-72 months 80% 73-84 months 60% 85-96 months 40% 97-108 months 20% 109-120 months 10% The credit for the defective fryer & pasta vessel shall be applied against the cost of the replacement vessel, utilizing Keating's then current price, upon return of the vessel to Keating, freight to be paid by Keating, only during the first 60 months, subject to the limitations described below. LIMITATIONS OF LIABILITY In the event of warranty claim or otherwise, the sole obligation of Keating shall be the repair and/or replacement at the option of Keating of the product or component or part thereof. Such repair or replacement shall be atthe expense of Keating except that the Customer shall pay the following expenses: all freight and labor expense for Keating replacement parts; for all other products, mileage exceeding 50 miles or travel more than one hour, labor costs of more than one person, overtime rates, truck charges, difference between ground and other mode of transportation, and holiday charges. Any repair or replacement under this Limited Warranty does not constitute an extension of the original warranty for any period for the product or for any component or part thereof. Parts to be replaced under this Limited Warranty will be repaired at the option of Keating with new or functionallyoperative parts. Keep Krisps and Computer Timers must be returned to Keating for warranty repair or replacement. Field repairs of those items are not authorized...

Herunterladen

Geben Sie zwei Ziffern: