Stimmen - 4, Durchschnittliche Bewertung: 4.8 ( )

Hersteller: GE Dateigröße: 1.09 mb Dateiname: 6ec61e42-d8f7-8c84-d5b2-00a102d5793c.pdf Unterrichtssprache:

Failure to follow all guides and rules could cause personal injury or property damage. • Check with your state and/or local public works department for plumbing codes. You must follow their guides as you install the Water Heater. NOTE: Failure to comply with these installation instructions will void the product warranty, and the installer will be responsible for any service, repair or damages caused thereby. BEFORE BEGINNING INSTALLATION Read these instructions completely and carefully. • IMPORTANT — Save these instructions for local inspector's use. • IMPORTANT — Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. A Recognize this symbol as an indication of Important Safety Information! SAFETY PRECAUTIONS WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result, causing property damage, personal injury or death. A, FOR YOUR SAFETY! - Do not store or use gasoline or other flammable vapors or liquids or other combustible materials in the vicinity of this or any other appliance. To do so may result in an explosion or fire. - WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. • Do not return to your home until authorized by the gas supplier or fire department. - Improper installation, adjustment, alteration, service or maintenance can cause property damage, personal injury or death. Refer to this manual. Installation and service must be performed by a qualified installer, service agency or the gas supplier. • This water heater must be vented outdoors using approved ducting materials. • Service information and wiring diagram are located behind front panel. • Service must be performed by a qualified service agency. • This appliance must be properly grounded and installed as described in these instructions. 49-50229-1 03-08 JR 1 Installation Instructions A DANGER Read and follow water heater warnings and instructions. If owner's manual is missing, contact the retailer or manufacturer. SAFETY PRECAUTIONS (cont.) A WARNING : Do not use substitute materials. Use only parts certified with the appliance. • This appliance must be installed, inspected and leak tested by a state- or city-qualified licensed contractor. It is the responsibility of the person having the water heater installed to ensure the installing contractor has proper licenses and permits for installing water heaters in your location. GE highly recommends that installers attend a product knowledge class to ensure customer satisfaction and warranty coverage. Failure to comply with state and local codes pertaining to water heater installations may void the warranty. • This appliance is not to be installed outdoors. • The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z2231/NFPA 54, or the Natural Gas and Propane Installation Code, CSA B149.1. • The appliance and its appliance main gas valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.5 kPa) (13.84 in W.C.). • The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa) (13.84 in W.C.). • Carefully follow the venting instructions beginning on page 19 and in the Maintenance section in the Owner's Manual for adequate combustion and ventilation air. • The appliance should be located in an area where water leakage of the unit or connections will not result in damage to the area adjacent to the appliance or to lower floors of the structure. When such locations cannot be avoided, it is recommended that a suitable drain pan, adequately drained, be installed under the appliance. The pan must not restrict combustion airflow. SAFETY PRECAUTIONS (cont.) • The flow of combustion and ventilation air shall not be obstructed. • This appliance is not suitable for use in an application such as a pool or spa heater that uses chemically treated water. (This appliance is suitable for filling large or whirlpool bath tubs with potable water.) • If a water heater is installed in a closed-water supply system, such as one having a backflow preventer in the cold water supply line, means shall be provided to control thermal expansion. Contact the water supplier or local plumbi...

Herunterladen

Geben Sie zwei Ziffern: