Stimmen - , Durchschnittliche Bewertung: ( )

Anleitung Crown, modell 50-004

Hersteller: Crown
Dateigröße: 401.01 kb
Dateiname:

Unterrichtssprache:

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

Bend the four Tabs in the wall face plate towards the outside when doing this. Do not attach the pipe to the plate yet. 6. Adjust the position of the terminal in the wall so that the edge of the intake skirt is 2-3” from the wall plate (Figure 1c). Also verify that the terminal is pitched in the same direction as the rest of the vent system. 7. Attach the intake/straight section to the wall face plate using the self drilling screws provided. Continued on Reverse Side 8. Loosen the hose clamp on the end of the exhaust terminal. Mount the exhaust terminal onto the intake terminal with the “V” horizontal (flue gas openings on top and bottom) as shown in Figure 1b. Slip the hose clamp over the “fingers” on the intake terminal and tighten the clamp. 9. Seal all exposed exterior joints, including the joint between the wall face plate and the wall and between the wall face plate and the straight section with an exterior grade silicone sealant. 10. Attach the intake tee to the end of the straight section protruding from the inside wall. Use the procedure described in (4) to clean and assemble these parts. 11. If the inside terminal section is not supported by the wall through which it passes, install additional supports or bracing to support the terminal. Bracing in contact with the coaxial section of the terminal may be combustible. INTAKE TEE EXHAUST CONNECTION CLAMP STRAIGHT COAXIAL SECTION INTAKE TERMINAL ■WALL FACE PLATE FOR 3" NOMINAL COAXIAL TERMINAL Y FOR 4" NOMINAL COAXIAL TERMINAL Y EXHAUST TERMINAL 5-1/4* 7-1/4" MAXIMUM WALL THICKNESS 13" FIGURE 1b: CROWN COAXIAL TERMINAL EXPLODED VIEW VENT ■ CONNECTION FIGURE 1c: CROWN COAXIAL TERMINAL ASSEMBLY...