Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Bradford-White Corp Dateigröße: 622.93 kb Dateiname: e35c1d7b-fd00-4c94-87bb-1e5482ed1ebb.pdf Unterrichtssprache:

WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electric switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion. D. Do not use this appliance if any part has been under water. Immediately contact a qualified service technician or contractor to replace a flooded water heater. Do not attempt to repair the unit! It must be replaced! WARNING If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. 1. STOP! Read the safety information above on this label. 2. Turn off all electrical power to the water heater. 3. Remove thermostat access cover. 4. Set the thermostat to lowest setting. OPERAOPERAOPERAOPERAOPERATING INSTRTING INSTRTING INSTRTING INSTRTING INSTRUCTIONSUCTIONSUCTIONSUCTIONSUCTIONS 7. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “B” in the safety information above on this label. If you do not smell gas, go to the next step. 8. At arms length away, turn gas control knob counterclockwise to the full “ON” position. WARNING Do not use gas control knob to regulate gas flow. 9. At arms length away, set the thermostat to desired setting. The 120°F (67°C) setting which approximates 120°F (67°C) is preferred starting point. If hotter water is desired, see instruction manual and “warning” below. 10.Replace thermostat access cover. 11. Turn on all electric power to the appliance. 12.If the appliance will not operate, follow the instructions “To Turn Off Gas To Appliance” and call your service technician or gas supplier. 5. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand. 6. Turn knob on gas control clockwise to “OFF” position. WARNING Hotter water increases the risk of scald injury. Before changing temperature setting see instruction manual. For operation at outlet water temperature not in excess of 180°F (82° C). TTTTTOOOOO TURN OFF GASTURN OFF GASTURN OFF GASTURN OFF GASTURN OFF GAS TTTTTOOOOO APPLIANCEAPPLIANCEAPPLIANCEAPPLIANCEAPPLIANCE 1. Turn off all electric power to the appliance if service is to be performed. 2. Remove thermostat access cover. 3. Set the thermostat to lowest setting. 4. Turn gas control knob clockwise DO NOT FORCE. 5. Replace thermostat access cover. to “OFF” position. 23 TEMPERATURE REGULATIONTo adjust thermostat setting, remove outer cover of the thermostat. The thermostat’s adjustment dial is labeled with a range of settings between 120°F (49° C) to 180°F (82° C). DANGER HOT WATER CAN SCALD: WATER HEATERS ARE INTENDED TO PRODUCE HOT WATER. WATER HEATED TO A TEMPERATURE THAT WILL SATISFY SPACE HEATING, CLOTHES WASHING, DISH WASHING, AND OTHER SANITIZING NEEDS CAN SCALD AND PERMANENTLY INJURE YOU UPON CONTACT. SOME PEOPLE ARE MORE LIKELY TO BE PERMANENTLY INJURED BY HOT WATER THAN OTHERS. THESE INCLUDE THE ELDERLY, CHILDREN, THE INFIRM, OR PHYSICALLY/MENTALLY HANDICAPPED. IF ANYONE USING HOT WATER IN YOUR HOME FITS INTO ONE OF THESE GROUPS OR IF THERE IS A LOCAL CODE OR STATE LAW REQUIRING A SPECIFIC HOT WATER TEMPERATURE AT THE TAP, THEN YOU MUST TAKE SPECIAL PRECAUTIONS. NEVER ALLOW SMALL CHILDREN TO USE A HOT WATER TAP, OR TO DRAW THEIR OWN BATH WATER. NEVER LEAVE A CHILD OR HANDICAPPED PERSON UNATTENDED IN A BATHTUB OR SHOWER. It is recommended that lower water temperatures be used to avoid the risk of scalding. It is further recommended, in all cases, that the water temperature be set for the lowest temperature that satisfies your hot water needs. This will also provide the most energy efficient operation of the water heater. SETTING THE WATER HEATER TEMPERATURE AT 120°F (49° C) WILL REDUCE THE RISK OF SCALDS. Some states require settings at specific lower temperatures. Short repeated heating cycles caused by small hot water uses can cause temperatures at the point of use to exceed the thermostat setting by up to 20°F (13°C). If you experience this type of use you should consider using lower temperature settings to reduce scald hazards. Valves for reducing the point-of-use temperature by mixing cold and hot water are available. Also available are inexpensive devices that attach to faucets to limit hot water temperatures. Contact a licensed plumber or the local plumbing authority.” Temperature Settings Time to Produce 2nd & 3rd Degree Burns on Adult Skin 180°F (82°C) 170°F (77°C) 160°F (71°C) 150°F (65°C) 140°F (60°C) 130°F (54°C) 120°F (49°C) Nearly Instantaneous Nearly Instantaneous About 1/2 Second About 1 - 1/2 Seconds Less than 5 Seconds About 30 Seco...

Herunterladen

Geben Sie zwei Ziffern: