Stimmen - 4, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Creda Dateigröße: 252.81 kb Dateiname: Unterrichtssprache:

Always ensure that the heater is switched off at both wall switches and the fuses removed before any repair is carried out. FIRST HEATING OF A NEW HEATER: The new heater will give off a slight smell and it is recommended this smell should be got rid of quickly by running the heater straight up to its maximum temperature, whatever the prevailing weather. Set both control knobs to the maximum settings of 6 and run the heater like this for two nights. The instructions to the installer of your heater mentions this and he will probably set it for you. The smell is normally harmless in a ventilated room and if possible, a window should be left open during the overnight charging periods. Caged birds, young children and people with chest ailments are best kept out of the room during the first period, USING YOUR HEATER: Your heater will be one of two types: either one with automatic control of the overnight charge or alternatively, one on which you adjust this manually from time to time. If necessary, check which heater you have, by looking at the model number located on the wall fixing angle. Heaters with model numbers 79341, 79351 or 79361 are automatic heaters, all other heaters require manual adjustment. The heaters store heat overnight while the cost of Economy 7 electricity is cheaper and discharge the heat gradually throughout the following day. They use no electricity during the daytime and will operate on any 'off-peak' tariff in addition to the Economy 7 tariff for which they are primarily designed. SHELVES: A shelf positioned above the heater will enable this space to be used because, as described earlier, it is not safe to place anything actually on the heater itself. Also, a shelf will cut down the dust streaking on the wall which sometimes results from the warm air rising from wall mounted radiators of all types. A purpose built range of shelves to suit the CNT heaters are available from your heater stockists or direct from Applied Energy Products Limited. A shelf unit must be positioned at least 1 0" (250mm) above the heater casing. 3.4kW heater shelf pack 79062 2.5kW heater shelf pack 79052 1,7kW heater shelf pack 79042 NOTE: If, during any reassembly of the heater a part of the thermal insulation shows damage or deterioration which may impair safety, it should be replaced by an identical part. Senmr Plus » : o > -iiV- I SETTING THE CONTROLS The controls are located under the lockable flap at the right-hand corner of the top panel. To adjust the controls on the heater use a coin and engage it in the siot provided on the top surface of the knobs v 6 AUTOMATIC INPUT CONTROL (SENSOR PLUS) After 48 hours of running at maximum control settings, the heater can now be adjusted j - ! to operate at its optimum performance. Piease use the following instructions as a guide. I ^ j ,s : 1. In the early afternoon to early evening, say between the hours of 2pm and 8pm, [ ^ 2 2 j turn the input control knob fully anti-clockwise until the...

Herunterladen

Geben Sie zwei Ziffern: