Stimmen - 4, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Crimestopper Security Products Dateigröße: 28.79 kb Dateiname: Unterrichtssprache:

This booklet contains the information necessary for using & maintaining your remote start system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at (800) 998-6880. OPERATION CAUTIONS & WARNINGS CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting from the use of this equipment. This system is designed to be professionally installed onto a vehicle in which all items, such as parking brake and all associated components, door switches, transmission shift linkage, throttle linkage, and all engine safety features, are in perfect working condition. DO NOT install this Remote Engine Starting System on MANUAL TRANSMISSION vehicles. If accidentally left in gear the vehicle could become a self-propelled threat to life and property. IT IS ABSOLUTELY THE OWNER’S SOLE RESPONSIBILITY TO: A) Understand the operation of this system and its safety features. B) Check for proper operation of these safety features prior to accepting delivery of the vehicle from the installation facility. C) Check and maintain the condition of the vehicle and all items relative to the proper operation of this system and its safety features. D) Always leave the doors and windows closed and locked to protect against accident and theft. DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is adequate ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes. IT IS ABSOLUTELY THE OWNERS SOLE RESPONSIBILITY TO: make certain the vehicle PARKING BRAKE is properly adjusted and will hold the vehicle securely in all parking conditions, and to periodically check and maintain proper adjustment. This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1) This device may not cause interference, and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. Such modification could void the user's authority to operate the equipment. OPERATING THE REMOTE TRANSMITTER (RS800 ONLY) OPERATING THE REMOTE TRANSMITTER (RS800 ONLY) The transmitter supplied with this RS800 system has (2) buttons / channels. #1 #2START LOCK/ REMOTE STARTUNLOCK CRIM ESTOPPER NOTE: When using the optional Starter Disable feature without power door locks, be certain to install the supplied L.E.D. which will be your only indication that the Starter Disable is active. You must press the UNLOCK button on the transmitter if the L.E.D. is flashing or the vehicle will not start. REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press remote start button or for RS801 model, activate the Green Start input wire. 2) Parking lights flash once, then turn ON along with the IGN/ACC circuits 3) After 6 seconds Starter Motor engages. (Parking lights and Acc circuits turn off while cranking.) 4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock. 5) Engine will remain running for programmed run time or until reset with Brake pedal. If needed, the engine can be turned off with remote transmitter or for RS801 model, activating the Green Start input wire again. AFTER IGN 6 STARTER THEN FLASH 1X SOLID SOLID SEC. START REMOTE ENGINE CONTROL REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2nd and 3rd time. For hard starting engines, the unit will allow a starter crank time of up to13 seconds maximum. This should provide ample cranking time for difficult starts, but is limited to 13 seconds to help prevent damage to the starter from over cranking in the ...

Herunterladen

Geben Sie zwei Ziffern: