Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
Canon shall not be liable for any loss or corruption of data. NOTES • About the Power Save mode: To save power when the camcorder is powered by a battery pack, the camcorder will automatically shut off if left without any operations for 5 minutes ( 98). Press to turn on the camcorder. ON/OFF 34 • When recording in very loud places (such as fireworks shows or concerts), sound may become distorted or it may not be recorded at the actual levels. This is not a malfunction. Using the Viewfinder When recording in bright places it may be difficult to use the LCD screen. In such case, change the brightness of the LCD screen* ( 26) or use the viewfinder instead. Press to activate the viewfinder along with the LCD panel. Close the LCD panel to use only the viewfinder. VIEWFINDER • You can pull out the viewfinder if it is more convenient. Hold out both sides of the viewfinder firmly and pull it out until it clicks. • Adjust the viewfinder as necessary with the dioptric adjustment lever. * The brightness setting is common to the LCD screen and the viewfinder. Selecting the Video Quality (Recording Mode) The camcorder offers 5 recording modes. Changing the recording mode will change the recording time available. Select MXP or FXP mode for better movie quality; select LP mode for longer recording times. The table on page 36 gives approximate recording times. FUNC. [ Standard Play 7 Mbps] Desired recording mode FUNC. NOTES • Discs created with the optional DW-100 DVD Burner that contain scenes recorded in MXP mode cannot be played back on AVCHD-compatible DVD players or Blu-ray Disc players (as of June 2008). Use the DVD Burner to play back such discs ( 85). • The camcorder uses a variable bit rate (VBR) to encode video so the actual recording times will vary depending on the content of the scenes. • The camcorder retains the last setting used even if you set the camcorder to mode. Video Approximate recording times .. Default value Recording mode > MXP* FXP* XP+ SP• LP Recording media v 60 GB Hard disk 5 hr. 30 min. 7 hr. 50 min. 10 hr. 50 min. 18 hr. 22 hr. 55 min. 120 GB Hard disk 11 hr. 5 min. 15 hr. 45 min. 21 hr. 40 min. 36 hr. 45 hr. 55 min. 4 GB Memory card 20 min. 30 min. 40 min. 1 hr. 10 min. 1 hr. 30 min. 8 GB Memory card 40 min. 1 hr. 1 hr. 25 min. 2 hr. 20 min. 3 hr. 16 GB Memory card 1 hr. 25 min. 2 hr. 5 min. 2 hr. 50 min. 4 hr. 45 min. 6 hr. 5 min. 32 GB Memory card 2 hr. 55 min. 4 hr. 10 min. 5 hr. 45 min. 9 hr. 35 min. 12 hr. 15 min. * Recorded in 1,920 x 1,080 resolution. Movies recorded using other recording modes are recorded in 1,440 x 1,080 resolution. Zooming mode: In addition to the optical zoom, digital zoom is also available ( 93). 12x Optical Zoom Move the zoom lever toward W to zoom out (wide angle). Move it toward T to zoom in (telephoto). Press gently for a slow zoom; press harder for faster zooms. You can also set / [Zoom Speed] ( 93) to one of three constant speeds (3 is the fastest, 1 the slowest). W TW T W Zoom out T Zoom in NOTES • Keep at least 1 m (3.3 ft.) away from the subject. At full wide angle, you can focus on a subject as close as 1 cm (0.39 in.). • When [Zoom Speed] is set to [ Variable]: -When you use the T and W buttons on the wireless controller or LCD panel, the zoom speed will be constant at [ Speed 3]. -The zoom speed will be faster in record pause mode than when actually recording. Quick Start Function When you close the LCD panel with the camcorder on, the camcorder enters the standby mode. In standby mode the camcorder consumes only about half the power used when recording, saving IMPORTANT Do not disconnect the power source during standby mode (while the indicator is lit in orange). NOTES • If you close the LCD panel under some energy when you are using a battery pack. Additionally, when you open the LCD panel, the camcorder is ready to start recording in approximately 1 second*, ensuring you do not miss important shooting opportunities. * The actual time required varies depending on the shooting conditions. 1 With the camcorder on and in a recording mode, close the LCD panel. • If you are using the viewfinder and the LCD panel is closed, press VIEWFINDER to enter the standby mode. • A beep will sound and the indicator will change to orange to indicate the camcorder entered the standby mode. 2 When you wish to resume recording, open the LCD panel. • The indicator turns back green and the camcorder is ready to record. • You can also press VIEWFINDER to resume recording using the viewfinder with the LCD panel closed. circumstances (for example, while the ACCESS indicator is flashing or a menu is being displayed), the camcorder may not enter standby mode. Check that the indicator changes to orange. • The camcorder will shut off if left in standby mode for 10 minutes, regardless of the [Power Saving Mode] setting ( 98). Press ON/OFF to turn on the camcorder. • You can select the length of time until shut-off or turn off the Quick Start function altogether with the [Quick ...
Dieses Handbuch ist für folgende Modelle:Kameras - VIXIA HG21 (4.58 mb)