Stimmen - 1, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
The camera video signal, color bar display signal or test display signal is selected by pressing the BAR switch and/or TEST switch. Both BAR and TEST switch lamps off: Camera video output BAR switch lamp lighted: Color bar signal output TEST switch lamp lighted: Test signal output CLOSE switch lamp lighted: Lens closed status with camera video output 8 AUTO WHITE BLACK SET UP 123 1Auto white balance switch [AUTO WHITE] This is used to automatically adjust the white balance. Lighted: This indicates that the automatic white balance adjustment has started. Flashing: This indicates that the automatic white balance adjustment ended without being completed. Off: This indicates that the automatic white balance adjustment was completed correctly. Parts and their functions 2Auto black balance switch [AUTO BLACK] 1Optical transmission alarm indicator [OPT ALARM] This is used to automatically adjust the black balance. This is the optical transmission warning indicator. Lighted: This indicates that the automatic black balance Lighted: The indicator lights when the optical signals adjustment has started. received in the transmission between the camera Flashing: This indicates that the automatic black balance and CCU are too weak or when a CCU optical adjustment ended without being completed. transmission receiver unit data error has Off: This indicates that the automatic black balance occurred. adjustment was completed correctly. If the optical signals received in the transmission 3Auto setup switch [AUTO SET UP] between the camera and CCU are too weak, an This is used to perform auto setup. The setup status is alarm display appears in character form. Check output to PM each time. the optical connector connections and mating. The mode settings are performed using AUTO SETUP If the problem persists, turn off the CCU power, MODE on the FUNC menu. disconnect the cable between the camera and OUTSIDE FULL: Standard setup based on the external CCU, and clean the optical contact area. Use shooting chart is performed. cotton swabs moistened with alcohol to wipe the OUTSIDE EASY: Simplified setup based on the external optical fiber part gently. shooting chart is performed. Off: This indicates that the signals received in the In either OUTSIDE mode, align the position of the 4:3 gray optical transmission are strong enough. scale (GS-3) wedge with the position of the 4:3 marker. Depending on the chart setting conditions, auto setup may 2Cable alarm indicator [CABLE ALARM] not go smoothly. For this reason, attention must be paid This is the camera cable warning indicator. to how the chart is set. Lighted: This indicates that the camera and CCU are not connected. Auto setup methods If the indicator is lighted all the time, turn off the Lighted: This indicates that the auto setup has started. CCU power, inspect and check the cables and Flashing at 1 sec intervals: connectors. If it still fails to light, consult your This indicates that the auto setup ended without dealer. being completed. Off: This indicates that the camera cable has been Flashing at 2 sec intervals: connected correctly. When the AUTO SET UP switch is pressed while the indicator is off, the auto setup start 3Fan alarm indicator [FAN ALARM] preparation mode is established, and a square This indicates that the CCU’s fan has stopped or that the marker appears in the center of the camera's camera’s fan is OFF. viewfinder. Roughly align this square with the Lighted: The CCU’s fan has stopped or the camera’s fan white at the gray scale center. Auto setup now is OFF. starts when the side switch is pressed. If the Off: Both the CCU’s fan and the camera’s fan are switch is pressed for 1 or more seconds, auto operating normally. setup is canceled. Off: This indicates that the auto setup was < Vertical frequency status indicator [60Hz] completed correctly. This indicates the vertical frequency status of the camera system. It remains off when the system’s operating