Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
• Battery CGA-DU12 is supplied. • The times shown in the table are approximate times. The numbers indicate the recording time when the Viewfinder is used. The numbers in parentheses indicate the recording time when the LCD Monitor is used. In actual use, the available recording time may be shorter. • The times shown in the table are for continuous recording at a temperature of 25 °C (68 °F) and humidity of 60 %. If the Battery is charged at a higher or lower temperature, the charging time may be longer. • We recommend the Battery Pack CGA-DU12 and CGA-DU21 for long time recording (2 hours or more for continuous recording, 1 hour or more for intermittent recording.) • The available recording time becomes shorter if you use both of Viewfinder and LCD Monitor simultaneously when rotating the LCD Monitor forward to record yourself. • The batteries heat up after use or charging. The Camcorder being used will also heat up. This is normal. For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: 13 Before Using Re-attaching the Lens Cap To protect the Lens surface, attach the Lens Cap. • The Lens Cap and Lens Cap Cord come preattached to the Grip Belt. 1 Pass one end of the Lens Cap Cord through the attached eye on the Lens Cap. Then pass the Lens Cap through the loop made by itself and pull tight. To Use as a Grip Belt Adjust the length of the Grip Belt to the size of your hand. 1 Detach the end of the Grip Belt. 2 Adjust the length of the Grip Belt to the size of your hand. 3 Reattach the Grip Belt. • When not using the Lens Cap, pull the Lens Cap Cord in the direction of the arrow. 1 • When you are not recording, be sure to cover the Lens with the Lens Cap for protection. 2 2 1 • When you remove the Lens Cap, press the knobs firmly. Attaching the Shoulder Strap We recommend that you attach the Shoulder Strap before going out to avoid dropping the Camcorder. 1 Pull the end of the Shoulder Strap through the Shoulder Strap Holder on the Camcorder. 2 Fold the end of the Shoulder Strap, run it through the Shoulder Strap Length Adjuster, and pull it. • Pull it out more than 1 inch (2 cm) 1 from the Shoulder Strap Length Adjuster so that it cannot slip off. • Attach the other end of the Shoulder Strap to the other Shoulder Strap Holder in the same way. 1 Inserting a Cassette • Please use Genuine Panasonic DVC Tapes for more information please contact your local dealer or visit • For your reference if you travel frequently you should also purchase a Panasonic head cleaning tape AY-DVMCLA and use when HEAD CLOG message appears on the LCD/EVF of your Camcorder. 1 Slide the [OPEN/EJECT] Lever 25 toward the front and pull down to fully open the Cassette Compartment Cover. • To protect the tape, if the cover is not fully opened, the cassette holder cannot be ejected. 25 14 For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: Before Using 2 After the Cassette Holder is opened, insert a Cassette. 3 Close the Cassette Holder by pressing the [PUSH] mark 1 . 4 Only after the Cassette Holder is completely housed, close the Cassette Compartment Cover by pressing the mark 2 . 1 2 • When inserting a cassette, orient it as shown in the above, and then securely insert it as far as it goes. .. When the Cassette Holder does not come out • Close the Cassette Compartment Cover completely, and then open it again completely. • Check if the battery has run down. • Check if the Cassette Compartment Cover is in contact with grip belt as shown below. If so, be sure the grip belt stays clear of the cover when opening. .. When the Cassette Holder cannot be housed • Set the [OFF/ON] Switch 26 to [OFF], then to [ON] again. • Check if the battery has run down. 1 Open the LCD Monitor and then slide the [