Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Bosch Dateigröße: 2.24 mb Dateiname: 6872100en.pdf Unterrichtssprache:

Repeat the process if necessary. Refit the grease filters when it are dry. Dishwasher machine • Place grease filters in dish washer. Select most powerful washing programme and highest temperatu- Fig. 3 re, at least 65°C. Repeat the process. Refit the grease filters when it are dry. When washing the metal grease filter in the dishwasher a slight discoloration of the filter can occur, this does not have any impact on its performance. • Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). Carbon filter • The activated carbon filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG activated carbon filter (see special accessories). • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100. C. After approximately three years of use, the carbon filter should be replaced with a new, as the odour reduction capacity will be reduced. • Mounting Remove the frame i which supports the filter h by unscrewing it from the hood g Fig. 4. Insert the coal mattress inside the frame and put all parts back in their place. • To dismount proceed in reverse order. • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. • The activated carbon filter can be ordered from the AEG technical assistance service. Fig. 4 igh Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb • Disconnect the cooker hood from the main supply. • Remove the lamp cover, use a screw driver as a lever. Fig. 5. • Replace the old bulb with a new one of the same type. • Remount the lamp cover. • If the light does not come on, make sure the bulb has been inserted in correctly before contacting the technical assistance service. Fig. 5 Cleaning • Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. • Only ever clean the switch panel and ...

Herunterladen

Geben Sie zwei Ziffern: