|
Anleitung Zusammenfassung
· The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the rangehood must be at least 65 cm. If the instructions for the hob specify a greater distance, please consider this. · The regulations concerning the discharge of exhaust air have to be fulfilled. INSTALLATION INSTRUCTIONS Electric Connection The appliance has been manufactured as a class II, therefore no earth cable is necessary. The connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral If not provided, connect a plug for the electrical load indicated on the description label. Where a plug is provided, the rangehood must be installed in order that the plug is easily accessible. An omnipolar switch with a minimum aperture of 3mm between contacts, in line with the electrical load and local standards, must be placed between the appliance and the network in the case of direct connection to the electrical network. If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the rangehood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. MOUNTING OF THE HOOD IN THE LOWER PART OF A HANGING CUPBOARD This appliance has to be built in the lower part of a hanging cupboard or in another support. For the fixing use 4 screws, which are appropriate to that kind of cupboard, drilling the holes corresponding to fig.1 and 2. CHANGING FROM DUCTED HOOD TO RECIRCULATING. To transform the rangehood from the extraction version to the re circulating one ask your supplier for an activated carbon filter. Active carbon filters are necessary to depurate the air, that will be released in the room. Filters are not washable; they cannot be regenerated and have to be replaced at most every 4 months. The saturation of the activated carbon depends on the more or less prolonged use of the hood, on the type of cooking and on the regularity of cleaning of the grease filter. The filter has to be fitted to the intake side of the motor, which is inside the hood. Place the filter to the centre turning - 5 it 90 degrees until the stop click is heard to lock it (F) fig. 3. Remove the grills (G) fig. 3 to carry out this operation. The air is released in the room through a connecting pipe, which goes through the hanging cupboard and which is connected to the connecting ring supplied (B) fig. 1. Recirculated to kitchen area via Recirculated to kitchen area via ceiling Ducted to atmosphere through wall Ducted to atmosphere through roof Rangehood Installation Exercise care when a rangehood is installed in an area where a gas burner is operating. Depending on the size of the room, the rangehood may draw from the room air that is necessary for proper combustion of the burner. All Blanco rangehoods are used for indoor application only. Rangehoods may be installed in two ways: 1. Ducted to the atmos...
Dieses Handbuch ist für folgende Modelle:Ventilatoren - BRU5G (1.03 mb)
Ventilatoren - BRU7G (1.03 mb)
Ventilatoren - BRU5G (1.03 mb)